cut the wires and the new solenoid will have the part to solder the cut wires together
The fuel pump is located in the Fuel tank.. the way to disconnect it would be to lower the tank and disconnect the connector.
in injector pump
If you mean the stop solenoid it is on top of the fuel pump. The fuel pump is at the front of the engine bay on driver side.
First, Remove the fuel Pump Relay then crank the motor for few seconds. Stop the motor, put the fuel tank down and disconnect the plug from the fuel pump.
On 2001 models the fuel filter is part of the fuel pump relieve the fuel pressure disconnect negative battery cable remove the back seat and take fuel pump cover off to get to fuel pump disconnect the electrical connector from fuel pump/fuel sending unit disconnect the high pressure hose and the fuel return hose from the fuel pump remove the fuel pump mounting flange screws lift the fuel pump and fuel pump or the fuel level sending unit separate the two units
Before
Fuel pump on EFI 4runners is located inside the fuel tank. Remove tank to access the pump. Remove 7 bolts then pull the pump bracket up and out of the tank. Remove 2 nuts and disconnect the wires at the fuel pump. Pull the pump out of the lower side of the bracket. Disconnect the pump from the fuel hose. Remove the rubber cushion and the clip. Disconnect the filter from the pump.....installation in reverse...
Yes, you can clean a fuel pump. However, you must disconnect the pieces and then clean out the interior of the pump with a fuel cleaning liquid.
Remove the fuel tank. Disconnect the fuel hose from the fuel pump to the junction of the carbs. Disconnect the fuel hose from the fuel filter to the fuel tank. Remove the fuel filter bracket. Keep track of the position of the fuel filter. Remove the fuel filter from the rubber holder. Disconnect the fuel pump electrical connector. Remove the fuel pump from its holder bracket A large screwdriver may be necessary to pry pump away from the holder bracket. . Remove fuel pump assembly. Remove remaining hoses from fuel pump. Installation is reverse of removal.
Disconnect fuel line from pump and start car...if it spits gas out, its working,if no fuel spits out, chances are fuel pump is not pumping fuel.
WHY DONT YOU JUST PULL THE FUSE TO THE FUEL PUMP
The fuel pump is located on top and inside the fuel tank. In order to replace the pump you must remove the fuel tank or disconnect the bed and slide it rearward.