0
Easiest would be to disconnect the wire at the emergency brake handle.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How remove hand brake fiero 1987?
It isn't a single part, so removing it would be a problem. If you wish to disengage the handbrake, apply light pressure to the button on the end of the parking brake lever. Lift the lever upwards (there will be some resistance) until the button presses inwards. With the button held in, lower the lever to the floor, then release the button.
Are there different flashers for the Fiero?
The Fiero has two flashers from the factory, the signal light flasher and the emergency or four way flasher. These are identical GM style two prong flashers. There are many quality levels and even a few novelty flashers available.
Should the orange buttom on the parking brake be up or down on a Pontiac Fiero?
It should be up so you can push it down to release the break.
Why wont your 85 fiero change gears when its started?
Could be a bunch of stuff, but some of the earlier Fieros had an issue with the shaft connected to clutch pedal bending which would cause the clutch to not fully disengage. When your car's not running you can shift gears all day without pushing in the clutch. Try that when your fiero's running and all you'll do is chew gears.
Where is the fuel pump located on a 1988 Pontiac Fiero GT and is there an emergency shut off switch that may need to be reset?
the fuel pumps on fiero's are in the fuel tank and I have never seen a shut off switch on them just a fuse in the fuse box under the dash
What is the Difference between TVs fiero and suzuki fiero?
Suzuki and TVs are motorcycles Pontiac Fiero is a very rare collectors sports car.
When was Pontiac Fiero created?
Pontiac Fiero was created in 1984.
Is there a brake conversion kit for a 1985 Fiero GT using Grand Am brakes?
There are many brake conversions available for '84-'87 Fieros. The grand am conversion isn't too difficult as I've completed it on my 86GT. The rears are pretty much direct bolt on, while the front requires some work at a machine shop to cut down the rotor/hub in order to mount the grand am rotors. I used 4 Front grand am rotors and calipers, and I changed the master cylinder to that of a 4x4 blazer. Visit www.fiero.nl for a wealth of Fiero information- it's pretty much the largest online Fiero community. West Coast Fiero also has a lot of information on brake conversion, and they sell complete kits. However, from my experience they are overpriced and their shipping time takes about 3 to 5 times longer than they'll tell you through email/phone calls.
How do you remove Pontiac Fiero blower fan motor?
Open your hood. Its in the middle between the AC aluminum thing and the brake booster. Simple one wire harness, these things are cake, 50 times easier on the fiero cause you dont have to sit on your head. Make sure its not the blower resistor first.
Will a Monte Carlo seats fit in a fiero?
No, Fiero seats are pretty special to fit in where they are. I recomend you repair your old with parts from the fiero store.
Where is the plug to add clutch fluid to a 1985 Pontiac fiero?
Drivers side near firewall similar to brake master cylinder only smaller; usually with a twist off cap.
What is the fuel pressure for 1987 Pontiac fiero?
what is the fuel pressure on a 1987 fiero gt
