The same as any other vehicle. Remove the drain plug and drain out all oil. replace the drain plug and tighten to approximately 10 lb/ft torque. Remove the old filter, apply oil to the new filter gasket, and install the new filter. Tighten the filter exactly 3/4 turn after it makes contact with the mounting surface. Caution: Tighten it no more or no less. Pour in the proper amount of oil at the oil filler cap, as outlined in you owner's manual.
need diagram of 1992 4wheel drive front hub disasembly
the proper tire size should be printed on a label on the drivers side door jam i have a 1992 Toyota 4wheel drive and mine takes P225\75 -R15
A4LD
The curb weigh of the 1992 Ford Explorer XLT 4-door with 4-wheel drive is 4,012 pounds. The Ford Motor Company has been producing the Explorer since 1990.
Actually , it has a timing CHAIN
Should be peel off typeRemove wheelsRemove caliper mounting boltsSlide caliper off rotorRotor should slide off hub
Nothing terribly dramatic. The maintenance doesn't change. My brother has about 243,000 on his Explorer.
With engine oil filter change ( 5 quarts )
Up until the 1995 Ford Explorer the only engine was the 4.0 L - OHV - V6
How do you replace evaporator on a 1992 ford explorer?"
No, the door on a 1998 Ford Explorer will not fit a 1992 Ford Explorer.
No.