what type of oil does the case 1840 require
The motor oil capacity of a Bobcat 763 skid steer is four quarts. The Bobcat 763 skid steer hydraulic oil capacity is three gallons.
10-30 motor oil with HTO additive
1840 engine holds 11qt or 10.4lt of 15-40 oil
14 quarts
10w30 or 15w40
thers one on the bottom of the oil tank, you have to remove the skid plate to get to it, and the outher one is on the bottom of the krank case by the shifter
You first must remove the rectangular skid plate underneath the engine. There are four 14mm bolts holding the skid plate. Removing the skid plate will expose the bottom of the engine where you will see the oil drain plug on the oil pan and the oil filter.
You have to remove the skid plate, then you can change the oil and filter
Every 250 hours.
A 320 is a skid steer loader and uses bobcat # 7003026 oil kit. Drain and refill is recommended every time the track is removed but listed on the 1000 hour service.
The oil level/fill plug is located between the tires low on the body. It's a plug that takes an Allen wrench to remove. Park on level surface remove plug. When full the oil is at the bottom of the plug hole. Capacity 6 quarts per side SAE 10W-30 engine oil. Oil change interval 500 hours. Drain plug location rear bottom. Drain and flush with solvent is recommended.