pull the plug on the bottom of the axle
or remove the cover if there ins't a drain plug.
To change the rear axle fluid you can remove the rear cover from the axle and drain it that way. If you don't want to remove the rear cover you can use a pump and a hose to drain it through the fill hole.
Remove rear axle cover, oil will drain out, reseal and install cover, fill fluid.Remove rear axle cover, oil will drain out, reseal and install cover, fill fluid.
The fill plug is on the rear cover of the differential. Remove the rear cover to drain the fluid.
To replace the rear axle seal on a 1965 GTO, start by safely lifting the vehicle and removing the rear wheels. Next, remove the axle housing cover and drain the differential fluid. Remove the axle retaining bolts, pull the axle out carefully, and replace the old seal with a new one, ensuring it's properly seated. Finally, reassemble the axle, refill the differential with fluid, and reinstall the wheels.
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
there is 2 different ways to change the fluid this is a drain plug on the front of the rear diff or you can take the back of the pumpkin off on the rear diff.
It's the oil/fluid that is in the rear drive axle (and front axle on 4x4).
To change the rear axle seal on a 1999 Mazda B4000 4x4, first, safely lift and support the vehicle. Remove the rear wheels and disconnect the brake components. Then, drain the differential fluid and remove the axle housing cover to access the axle shafts. Carefully extract the axle shaft, remove the old seal using a seal puller, and install the new seal before reassembling the axle and refilling with fluid.
If there is not a drain plug on the bottom of the differential then you will have to remove the cover. Be sure that you service it with the proper fluid and positraction additive if it is a positraction differential.
oil for what rear axle ,ayc unit,gearbox,transfer box ,front diff or engineo or the brake fluid
To replace the rear axle seal on a 1965 Ford Fairlane, first, safely lift the vehicle and remove the rear wheels and brake drums. Then, remove the axle housing cover and drain the differential fluid. Carefully pull out the axle by removing the retaining bolts and gently sliding it out, taking care not to damage the bearing. Finally, install the new seal into the axle housing, reassemble everything in reverse order, and refill the differential fluid.
synthetic gear oil