The best method I've come across is 1. mark the precise center of the hole you'd like to drill. 2. take a hardened nail, or a nail set with a 1/32" or less head, and tap it gently with a hammer to just break the surface glaze of the tile. 3. the small break in the glaze will allow you to slowly (no percussion) use a quality carbide masonry bit to make the hole. The bit has a tendenct to "walk away, and off of" your mark without using step 2. hopefully you are not partially on a grout line with your target hole. Good luck!
Tiles used on floors tend to be thicker than wall tiles. Also, floor tiles are subjected to flexing as people walk over them. Therefore, if floor tiling a wooden floor, use a flexible cement adhesive and grout designed to give and take without cracking.
No, the adhesive won't hold.
i think you should drill through the wall slowly The question was about drilling an hole in a mirror. I think the correct way to do this is to mark out where the hole is required, get some putty and form a cupped mound below, fill with varsol or white spirit, and drill the hole slowly with a special glass drill bit. You must keep the bit lubricated with the liquid to dissipate heat and prevent the mirror from cracking.
yes
Assuming it's a 4x4 wall, 64 tiles
80
No.
with plaster or Cement.
(trick question? find a more narrow wall.) They sell drill bit extensions - metal rod. OR measure carefully and drill from the other side. Or find a drill bit that is long enough.
Most sandstone houses were built with a lime mix. The lime allowed the walls to move without cracking.
Please explain what is a "fines wall"
wall tiles are used on walls. floor tiles are used on floors. if you want to interchange. you can make the wall tile as floor tile and vice-versa