Drill through the lock. There is a "gear" on the back of the lock. Try not to drill through it. After you drill through the lock you can use a screwdriver to turn that gear to the right position (RUN or ACC )depending on what kind of car you have. Then all you have to do is remove the steering wheel and mis. parts to get to a screw that holds the ignition switch in. Then remove the lock and install the new one.
Drill it out............
You would have to drill out the center of the lock or have a locksmith pick the lock.
Remove steering wheel Remove Steering lock plate Place ignition in on position Depress lock pin now exposed. If this is not possible, drill out lock pin.
Without the key you are going to have to drill it out.
Most locksmiths can cut a key with your VIN. Or a dealership.
How to drill out ignition switch on 1985 ford f150?
drill through the release pin
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
1996 rodeo- how to remove key from lock ignition?
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
Begin by removing the retaining ring at the top of your 1996 Chevrolet Silverado ignition lock cylinder. Slide the ignition lock out and remove the wiring harness. Reverse the process to install your new ignition lock cylinder.