0
in wood, drill a hole so a wooden dowel can be firmly tapped into hole. In metal, you can use a welder to fill in the hole, or thread the hole, cover a threaded screw with "non-serviceable" lock-tight, put the screw in the hole, cut off the head, and grind flush.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you measure circumference and area of circle?
you drill a hole in it then fill it with water then pour it into a cup and measure it
Can you drill a hole in the sides of a brinks safe?
You can drill a hole in the side of anything with the right drill.
If you drill a hole 40 feet deep by 24 inches in diameter how much concrete will it take to fill it in?
18.6240 yd³
A can be used to cut a round hole in wood?
you can cut a hole in wood using a special drill attachment. alternatively you could drill a hole then cut a hole with a jigsaw
How do you make you wheels?
Get some paper wrap it around the wheel take the paper off tape it closed then fill it with urathane then drill the small hole and the big hole and ur done
How to Drill a hole in a marble tile?
With a Diamond drill bit and water. Keep enough water around the bit to keep it relatively cool. If drilling through a counter make a dam around the area where the hole will be with plumbers putty. Fill with water and slowly drill.
What size drill for 12 metal screw?
If you want it to grip, drill a 9/64 hole. For a clearance hole, drill 7/32.
How do you repair an unsuccessfully drilled hole in a concrete wall so that it is strong enough to be re-drilled in the same place and support a reasonably heavy wall mounted cabinet with a rawl plug?
Go to the next size concrete lag shield anchor or rawlplug. If this is not workable,drill the hole to 1\2 and fill with high strength morter. = =
If you are drilling a hole in a wall with an electric hand drill then what action will make the hole be drilled?
The rotating action of the drill bit makes the hole.
How do you drill oval hole?
slot drill on milling machine
How do I drill a half inch hole in sandstone?
by using a drill
How do you cut or drill through a fixed wall mirror to mount a light fixture?
i think you should drill through the wall slowly The question was about drilling an hole in a mirror. I think the correct way to do this is to mark out where the hole is required, get some putty and form a cupped mound below, fill with varsol or white spirit, and drill the hole slowly with a special glass drill bit. You must keep the bit lubricated with the liquid to dissipate heat and prevent the mirror from cracking.
