It will cover them and maybe fill them in a little but you should fill them in with food filler first.
yes
They way to repair a rocking chair depends on what is wrong with it. If it is a crack or chip one can fill it with wood filler. If it is warped you can shave or sand some wood off to make the surface smooth.
no
If it is a deep scratch you can use a wood filler putty, if it is a light scratch you can buy markers in many different wood shades and just fill in the lines. If the scratch is light enough and you are in a pinch a brown crayon will help cover it up.
It is called filler paper because it is used to fill a notebook or binder.
NO - it's not a gap filler at all. Before you use this you should fill all gaps with a filler compatible with the product.
With a concrete crack filler
Sand the area where the groves are. This will clean the area for the next application. Assuming the the panels are made of wood in this instance then purchase a good quality wood filler. This is bettter than wall fillers which are made of a silica powder as the wood filler allows for some expansion in wood. Fill the joints with the filler leaving it slightly proud of the groove. Then using either an electric sander or an 80 grit sand paper wrapped around a wood block sand the joint until its smooth and flush with the surrounding panels surface. Make sure that you leave at least 12 hours between filling and sanding to make sure the filler in its depth is hardened. then prime, lightly sand,wipe all dust off, undercoat, sand with a light 220 grit and wipe againt to remove top dust and then apply the top coat x 2
fuel vapor escaping as you fill up. the malibu's filler neck does have a vent tube attached to it to allow vapors a route to ecsape while you fill up
filler materials are used to fill the gap between the two job materials during the welding process
The fuel tank filler neck is the metal pipe attached to the rear fender that you insert the gas nozzle into to fill your tank.