0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is part of a rafter?
A rafter is part of a roof, it supports the roof.
What is roof overhang?
Typically, it is the part that extends beyond the building wall, aka tail of the rafter. It creates the area where you can stand under the edge of the roof when it rains.
Instructions for swires roofing square?
The figures on the outer edge of the curve are degrees. Use these to set the angle/pitch of the roof. The figures on the inner edge of the curve are a ratio of the length of common rafter per foot or metre of run or span of roof. Take half the span of the roof in feet OR metres and multiply by the figure for the pitch of your roof this will give you the length of your rafter from birds mouth to the centre of the roof. Then make a deduction of half the thickness of the ridge board. at right angles to the bevel . The easiest way to use the bevels/angles from the square is to place the square on a piece of ply or board and mark all the bevels/angles onto the board and then use a sliding bevel/bevel square to apply the bevels/angles to the rafters and other members of the roof. No 1= Plumb & Seat cut for the Hip No 2=Plumb & Seatcut for Common Rafter No 3=Edge cut for the Hip (Mitre) No 4=Edge cut for Jack Rafter No 5=Side cut for Purlin No 4A=Edge cut for Purlin (Mitre) No 6 Lip cut to Purlin .This is the sloping cut which goes under the bottom edge of the Hip where the Purlin abutts to the Hip Rafter
How do you decide the common rafter length in a hipped roof?
use the 17" on your rafter square
What is the actual rise of a roof rafter?
Depends on what pitch the roof is. Measure the ceiling joist to a point or to center and then plumb to the rafter and do the math. 3, 4, 5, x 12 pitch rises that much per foot of distance on the ceiling joist. 3x12 pitch, 12 feet to center of joist, 3x12=36. 36 inch rise from the edge of the roof to the center.
What is another name for roof support or wooden beam Is 6 letters long.?
A common synonym for "roof support" or "wooden beam" that is six letters long is "rafter."
What is better a roof truss or rafter?
They each have their place, but on the same style roof, trusses would be stronger.
What is the standard spacing of a roof rafter 2x6?
Rafters are usually on 2 ft. centers.
What is the name of the edge of the roof called?
eave The overhanging edge of a roof.
What is the overhanging edge of the roof?
The overhanging edge of a roof is called eaves.
What is the overhanging edge of a roof?
The overhanging edge of a roof is called eaves.
What has the author George McEwin written?
George. McEwin has written: 'Rafter lengths, roof bevels, and the steel square' -- subject(s): Roofs, Tables, Rafter gages
