It should be the same as the subnet mask for your PC. To check go to My network places, right click open properties, right click on local area connection and open properties, click on tcp/ip and then click on properties. You should now be looking at your ip config for your PC subnet mask and default gateway should be the same on the printer as on your PC. Or you can open a command prompt Start-run-type in cmd than type in "ipconfig" (no "")
255.0.0.0The default subnet mask of a class A network is 255.0.0.0
Subnet mask defines our network bit . If we are using a single network then all computers should have same subnet mask as well as the ip address, that belongs to the same network id.
The correct term is subnet mask instead of subnet mass. A subnet mask separates an IP address into the host address and the network address. It is a 32-bit number that can mask an IP address.
If this is a default subnet mask, then it would be a class C subnet mask. If you are subnetting a network and this is not the default subnet mask, then it could be either a class A or class B.
195.85.8.0 is a class C network. The subnet mask would be 255.255.255.0 and the network address is 195.85.8.0
The network address of an IPv4 address of 192.168.7.5 with a subnet mask of 255.255.255.0 would be 192.168.7.0. Remember that the subnet mask determines the network portion of the IP Address.
Without a subnet mask a client is not able to participate on a network because the network software is unable to determine the network addresses.
This is a network address
Any device (mac or not) receives its subnet mask from the DHCP service, or by manually configuring the interface. In the case of manual configuration you would need to check with your network administrator to find out the correct setting for the subnet mask.
Since this is a Class C address, the default network mask is 255.255.255.0.Since this is a Class C address, the default network mask is 255.255.255.0.Since this is a Class C address, the default network mask is 255.255.255.0.Since this is a Class C address, the default network mask is 255.255.255.0.
The subnet mask separates the network id from the client id in the IP address for a sender or receiver.
hi how to find network configuration if remote machine having window operating system