I replaced the crank position sensor in my 90 Lumina 3.1L! It was on the back side of the motor and with a little patience I was able to R & R!! I went from the bottom of the engine between the block and transmission! I didn't have to removed any splash guards or other items just needed patience
ANSWER......... It's in a hard to find place; got it from under the car, its in between the oil pan and the trany. At the top of the oil pan in the block on a downward angle. There are two other thinges in the block just above it to the right. (looking from under the car)
have alternator been checked for voltage output
I belive that there is no adjustment on the serp belt on your lumina. Should be a spring loaded tensioner. If you are having problems with the belt slipping you most likely need to replace the belt/ tenssioner.
On a 1996 Plymouth Breeze, the crankshaft sensor can be found above the oil filter. It should be accessible without having to remove any other parts.
Yes. Linux can be installed on a computer without ever having installed Windows, and can be installed to replace Windows entirely later on.
Many times, it is possible to use an epilator for 10 to 15 years without having to replace it. This will help you save money from having to buy disposable and electric razors.
I have been having problems with finding the crankshaft sensor, what should i do or what can i do?
how do you replace the alternator on a 2002 ford escape,without having to remove the the right side intermediate axle shaft?
My 1993 Chevy lumina did the same thing i ended up having to get a new battery it turns out my factory radio was the problem : - )
A machine shop can repair it if it is not damaged too severly. You may end up having to use oversize bearings. If it were me, I would replace it if it has very much damage.
Having the diagram of the engine to the car being driven can come in handy. A person can find the 1997 Chevy Lumina Engine diagram in the maintenance manual.
According to auto stores there are two crankshaft sensors. One is behind the crankshaft and I'm not sure where the other one is located. Having the same problem with the second one that has 2 prongs.
Hot-swappable. p1087 A+ Guide 6th edition
Replace the flapper. If that doesn't work, try a Flusher Fixer Kit.
you dont without cutting the plate
The crank sensor is not in the distributor, it is in the top of the bell housing. The cam position sensor is in the distributor and is not available separately
How do you replace thermostat housing in 1999 Jaguar XK8? Can't seem to remove bolts without having to remove value covers. Help
No, the 390 uses a C6 transmission and the 289 uses a smaller C4.
You can get chlamydia without having your period.
You can not carry herpes without having it.
They replace each other by starting wars, or if an emperor dies without having a son then someone must be chosen to take over. But mainly by war.
This question is asked poorly. Are you having trouble starting your Hyundai, or having trouble with your crankshaft sensor? Asking your question correctly will get you the correct answer. If your car isn't starting, I would suggest looking over the cranking system. (Battery, alternator, starter etc)... To find out if your crankshaft sensor is a problem, you could use a computer diagnostic tool.
If not replaced having it resurfaced is recommended.
Had that problem once and i was told to drive my car 30 miles without having to stop at any stop lights or any signs . Did this and mine fixed itself at 31 miles.it is a 3.1 engine.
Yes you can open windows with broken sash cords; however, the windows will probably not stay open unless you replace the broken cords.
If the reservoir is blocking the way, then it will have to be removed.