On the 92 Accord (probably similar to Legend) the VSS is boat-shaped (square on one end and pointy on the other. It has a three wire connector and is mounted on the top of the transmission directly under the thermostat housing. To change it you unplug the wire connector and remove two 12mm bolts. Take care not to lose the white plastic drive pin. Typically these are on the top of the tranny so they don't get as wet. The three wires are +12, gnd, output (+5V pulse).
You have a bad Vss Sensor.............. The vehicle speed sensor.
how to replace a water pump on a 1991 acura legend
VSS=vehicle speed sensor. That acronym is the same for all OBDII compliant vehicles
how do u find and replace a 92 acura legend thermostat
how to replace rear shocks on a 1994 acura legend coupe
The camshaft position sensor on a 1991 Acura Legend is located at the back of the camshaft, near the rear bearing cap. It monitors the rotation of the camshaft and relays this information to the vehicle's computer.
How do I put a alternotor belt on a 1991 Acura Legend
The map sensor for the 1991 Acura Legend is mounted on the firewall. It is in a box near the factory strut brace.
replacing headlights on a acura legend 1995
Need to know if you are asking about the vehicle speed sensor, a front wheel speed sensor or rear wheel speed sensor.
The 1991 Acura Legend does not have an oil temperature sensor. It does have an oil pressure sensor. The oil pressure sensor will be located on the left-hand side of the engine.
its in front of car in the exhaust manifold, u need a special socket to remove oxegyn sensor. fairly easy