The ID is the inside diameter, you can use a tape measure and measure the open end of the pipe from inside edge to opposite inside edge
wall thickness of pipe is (OD - ID) /2
assuming it's hollow. 10.68*ID*(OD-ID)
Can you calculate the ID of a pipe when you have the OD to be 10.75" and the wall thickness to be 0.5"Depends on what you know about it. If you have the outer diameter and you know the wall thickness, then ID = OD-2 x wall thickness
3 Inches.
Need to know how long the pipe is first.
id means inside diameter, od means outside diameter, copper pipe and tubing is measured by the od, therefore the od the pipe or tubing will be the same as the id of the fitting
The inside diameter (ID) is 8 inches. The nominal pipe size (NPS) and outside diameter (OD) depend on the thickness of the walls of the pipe.
Find the circumference of the exterior of the pipe, then find the circumference of the interior. subtract the two to find the thickness of the pipe. then multiply the length of the pipe. Now you have the mass of the pipe, so calculate that into the weight of steel or aluminum or whatever the pipe is made of.
The gap is going to be 5/32 with the pipe centered. You could weld it.
For a given pipe size, schedule 160 would have the smallest ID (and thicker wall). Wall thickness and pressure rating goes up with increasing schedule number, causing the ID to go down with increasing schedule number.
id definetley go with a bill ballance hmf pipe without quiet core it will scream
0.785 Cubic feet