It usually enters the house in a basement or garage. There will almost always be a PRV and a main shutoff valve where it enters. Look in those places.
On Ur main cold water line on house Looks like a brass cone
Locate your main water line inside house and shut the water off. Cut pipe and place a tee solder into place. Run your line to exterior of house placing a shut off inside.. Test for leaks..
Area water authority could have increased water main pressure, no or defective expansion tank in house main water line if house has a backflow preventer installed, or defective /not properly set pressure reducing valve.
You shouldn't have a problem finding a reducer at a home/builders supply house.
Turn off at curb stop to decommission whole house or building. Inside of house or building, turn off valve at main water supply at meter and cut and cap cold water line to be decommissioned.
On Ur main cold water line on house Looks like a brass cone
how deep should water line be from meter to house in Versailles Kentucky
Certainly
Every geographical area in the wrld is different. Find out how deep the Frost line is for your area and bury the water line six inches to one foot below that.
There is usually a small water meter fitted in-line of the water pipeline. You'll find it near the property boundary, where it can be easily read by a meter reader.
aint' no such thing!!!
you would see it by the meter unless your house has a shutoff in the interior, then it could be there.
you do not have pressure from the source or the line from the source has broken
It will be close to the inside wall where the water supply passes into the house from the line going towards the water meret.
Locate your main water line inside house and shut the water off. Cut pipe and place a tee solder into place. Run your line to exterior of house placing a shut off inside.. Test for leaks..
water going under slab into the house. is not a water line leek.
bec. of the gravity.