I wonder why you would need that info when you just buy a new pvc valve and replace it.
Change out the gas flow orifice size to propane and adjust the gas valve.
It doesn't use a PCV valve. It is a orifice ventaltion system. The rear elbow in the valve cover is a fixed size orifice and that hose hooks to the intake. The front elbow is a larger hole and it hooks to the air cleaner. Check all hoses for being plugged.
Why, did you break your tube? The best way to fix this is to go to a salvage yard and get another tube. The diameter size of the tube is about 1/2".
Yes. But it is limited in control by the orifice size, pressure applied and piping diameter. In other words it is "fixed". An example would be the metering device in a refrigerant circuit, specifically an orifice or capillary tube. The same physics apply.
The rear elbow coming out of the valve cover has a fixed size orifice. The crankcase gasses vent through there and into the intake.
There is a plastic twist off cap on the passenger side of the intake. The pcv is there.
AnswerYou need to buy a special valve or converter a special valve or converter is NOT necessary. typically the stove burners each need a newer smaller orifice. they are litle socket type brass fittings about 1/4" in diameter (the hole, the orifice, is much smaller)the new orifice can be bought at a applaince part distributor or on-line.the oven typically justs needs an adjustment. no replacement parts are necessary
Orifice size corrected to reference temperature.
It is best to contact the appliance manufacturer for correct orifice size when converting from one type of gas to another.
The same size as the pipe it is hooked up to in the well.
The normal way is to open the prime valve, start the machine in paint or water, then close the prime valve once the fluid starts flowing through the prime line. If the machine will not prime, tap the piston with a hammer to loosen the check balls. If it is a diaphragm type machine, remove the intake hose and shove a pencil, eraser first, in to the inlet to free the ball or valve. If the prime valve is broken, you can prime the machine by starting the machine in water, trigger the gun and hope that it pushes the liquid to the gun. Once it starts pushing water through, switch to paint which will push all the water out.
Engine Size? Anyways, look on one of the valve covers, I believe you will find it there.