Want this question answered?
its the hvac blend door motor crunching up the doors if you have the digital climate control
Remove the instrument panel silencer from the passenger side of the instrument panel. Disconnect the wire harness connector from the blower motor. Remove the three screws that secure the blower motor to the HVAC housing. Remove the blower motor from the HVAC housing by rotating and tilting the motor as needed for clearance of the blower wheel....
Right side of the vehicle, under the hood, in the HVAC compartment.
There is none. This vehicle does not have a air filter for HVAC ventilation.
The front blower motor is attached to the bottom of the HVAC housing, under the dash, on the driver side. The rear blower motor is inside the trim panel, on the right rear of the van.
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch . Depress the latch on the blower motor resistor wire harness connector and disconnect the connector from the resistor. Remove the two screws that secure the blower motor resistor block to the HVAC housing. Remove the resistor block from the HVAC housing............
fan motor protector
It should be called the auto HVAC blower motor resistor wire harness. Goes from the auto climate blower motor resistor to the blower motor.
Brake horsepower is the hvac motor horsepower before the motor hp is dropped due to a load. Indicated, gross and SAE are other ways to rate horsepower.
Not knowing what the vehicle is, they are generally found close to the blower motor.
HVAC blower motor going bad could make a rumbling noise in the car near the glove box
The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed without having to remove the instrument panel or the HVAC housing.Disconnect and isolate the negative battery cable.Disconnect the wire harness connector from the blower motor .Release the locking tab that secures the blower motor to the HVAC housing and rotate blower motor counterclockwise.Rotate and tilt the blower motor as needed for clearance to remove the blower motor and wheel from the HVAC housing.