first off, does the jack have hydrolic oil in the resevoir? if not, fill it up and try again. if this still doesnt work the "o" ring has probably rotted and needs replaced or just go buy a new jack. hope this helps you.
You need a 3 ton jack to lift your MDX 2006
Yes
10,000 pounds
2 tons? Duhhh!
It won't work, you'll just break the jack if you try. You'll need a 3+ tonne jack for sure.
Yes. I have a 6 ton 8 inch lift Rees jack made fo PA
4,000 foot pounds of energy (work) for each foot highyou lift it off the ground,regardless of whether you do it with a lever, a pulley, a jack, a hydraulic lift, oryour bare hands.
The solution to Car Ton Jack is: Jack in the box for Jack in Carton.
NOPE. I just tried. It is listed at 3600 lbs. However I would go with a 2.5 or 3
Assuming you have checked the hydraulic fluid and it's OK, you could look into replacing the seals on the compression cylinder, but with jacks as inexpensive as they are these days, it would be easier and maybe even cheaper to replace the jack. I routinely see two-ton jacks on sale at automotive stores for $20-30. just check the rubber seling at bucket's bottom of the ram and plunger they wear of.f
1 ton
yes. a ton is 2000 pounds. and if the jack is a 2 ton capable jack then its able to hold 4000 pounds