you cant so dont bother trying.
check your fuses. check the bulbs. maybe replace the turn signal relay Check the fuse box. The fuses may have blown it is very easy to do and only costs about 20cents to buy a new one.
Turn on that fast blinking signal light and check to see if the front and rear signal lights are both working, chances are you have a burned out bulb. If both front and rear bulbs are flashing fast, replace the flasher relay.
Either Some ones TV stops working or America will Nuke China because they think the shot down their satellite. Whatever happens it will result in the end of the world, one way by radiation, the other by boredom.
Loose or corroded socket? Bad ground?
Check/change the fuse associated with the blinkers.
Try changing the channel to 611 to restore the signal strength. If that doesn't work, contact your service provider and have them give you an estimate to get it fixed.
Its the turning signal/flasher module, left side of dash behind the fuse box. Its a dealer part only about 98.00
A weak satellie signal normally suggests that the dish is too small or perhaps that the dish is not set up correctly. A fraction of a degree out of alignment can make a big difference to the signal strength and quality. Checking and correcting connectors and perhaps replacing the cable with a lower loss type can also make a noticeable difference. Satellite set up is a specialist operation and it is probably worth calling a satellite company who will diagnose and fix a problem on a single visit.
If you have no signal coming into a digital converter box, you either have no service or you have a broken connection between the service provider and the box.If you have no signal coming out of a digital converter box, you either have no service, or you have a broken box, or you have some kind of short on the output.If you have no service, then you need to contact the service provider. If the box or the circuitry is bad, you need to fix it, or you need to contact the service provider.Any other meaning to this question constitutes a request to know how to defeat the security of a digital converter box. That is an illegal activity, and WiKi Answers does not provide answers for those type of questions.
You fix it cause its broke.... Check the left bulb
I believe the answer is three.
check for a loose wire at the fuse box
Usually a no signal message means that the video card is not detecting the monitor. An easy way to fix this is to download the latest drivers for your video card and it should detect the monitor.
how do you fix turn signal
I had this problem on a few (not all) channels and found a couple of solutions: 1) Try a Foxtel set top unit (STU) reboot - this fixed some of the problem channels. 2) Try a power reset - did not seem to do anything but seemed like a good idea. 3) Check your Foxtel cable wiring - this fixed all my other problem channels. Set Top Unit Reboot On my STU I had to simultaneously hold down then release the Back and Select buttons on the set top unit. All the STU lights can on then shortly only the Power On light remained. (Your STU may have a different reboot mechanism.) Power Reset Turn off your STU using the remote then unplug it from the mains. Leave it off at least 10 seconds or more then plug it back in. You may also want to remove and re-insert the smart card just to make sure the chip contacts are 'good'. STU Cable Wiring To be safe you may want to do this with the STU unplugged from the mains power. Essentially just verify that all the Foxtel cable connections are well 'set'. Try dis-connecting the cable and reconnecting. Do this for both ends of the cable between the wall and STU. If applicable, also any other connections back through to where the Foxtel cable enters the premises. (Also if you have more than one Foxtel STU, you can try swapping the STUs and/or cables around to try pin-pointing the problem.)
The satellite may need to be readjusted a little. You can call your provider to find out the steps to take.
my turn signal works but my switch will not return after i make a turn. please explain to me how to fix the problem