answersLogoWhite

0

If your 1992 Pontiac LeMans won't shift into gear, first check the Transmission Fluid level and condition, as low or dirty fluid can cause shifting issues. Inspect the clutch fluid and the clutch master/slave cylinder for leaks or damage if it's a manual transmission. Additionally, examine the shift linkage and cables for any obstructions or misalignments. If these steps don't resolve the issue, it may be necessary to consult a mechanic for further diagnosis and potential repairs.

User Avatar

AnswerBot

3mo ago

What else can I help you with?

Related Questions

Why wont your Pontiac take off when you step on the gas?

Shift into gear first.


Why won't your Pontiac Sunfire shift gears?

fluids are fine, no codes, and it wont shift past 2nd gear. any help?


How do you change a bulb in Pontiac grand am gear shift indicator?

I have a 94 Pontiac Grand AM SE and replacing the bulb on gear shift is difficult. The whole panel that the gear shift sits on can be remove. First pull the pin out from the shift knob its located in the front of the knob just above the metal rod it sits on. Then pull out the knob. After that just pry out the panel carefully at the sides, starting from the cigarette lighter up to where the switch is to adjust the mirror. Disconnect the wire from the cigarette lighter, gear shift and the switch that adjust the mirrors. The bulb is on a circuit that is one with the gear shift indicators.


How do you change the Gear Shift Bulbs on a 2003 Pontiac Aztec?

To change the gear shift bulbs on a 2003 Pontiac Aztec, first, disconnect the negative battery cable to ensure safety. Remove the gear shift trim by carefully prying it away from the console, then locate the bulb sockets beneath the gear shift. Twist and remove the old bulbs, replacing them with new ones, and reassemble the trim before reconnecting the battery. Test the new bulbs to ensure they work properly.


What would make your key get stuck in the ignition of a Pontiac Aztec?

i have that problem to it has something to do with the gear shift censor


How will it cost to repair the gear shift linkage in a Chevy Trailblazer?

I live in Forest Park, Ga, and my gear shift got stuck and would not move, had it checked out and it was the gear shift cable, the price at Hessessy Pontiac was $85.00 but i found it at Terrry Cullen Chevrolet for $66.00 and $30.00 to install...


3003 Pontiac aztek gear shift wont move?

If the gear shift on your 2003 Pontiac Aztek won't move, it may be due to a few common issues. Check if the brake pedal is fully depressed, as the shift lock mechanism requires this to allow shifting. Additionally, ensure that the ignition is in the "On" position and that the gear shift is not stuck in park. If these steps don't resolve the issue, there may be a problem with the shift linkage or the transmission itself, which may require professional inspection.


What does it mean when the transmission wont shift out of first gear on a 1992 Buick Roadmaster?

If the transmission won't shift out of first gear on a 1992 Buick Roadmaster, it could indicate the transmission gears are seized. It can also indicate a low fluid level.


What transmission is in a 2001 Pontiac Grand Am GT?

standard (shift gear) 5 speed Automatic 4 speed


What is the gear ratio of a 1967 Pontiac lemans with a 326 engine and automatic transmission?

The gear ratio for a 1967 Pontiac LeMans with a 326 engine and automatic transmission typically ranged from 2.56 to 3.08, depending on the specific setup and options chosen. The most common rear axle ratio for this model was 3.08. However, it's important to verify the exact ratio by checking the vehicle's identification or rear axle tag, as different configurations and options could affect this specification.


Why does your Pontiac every once in a while shift hard between 1st and second gear?

its because of the dramatic gear change, first a second gear have bigger differences in size compared to the rest of the gears


How do you diagnose or fix an automatic 1992 Pontiac Grand Am Se that occasionally slips out of gear completely but only goes back into gear once restarted?

==headline==