on a 93 Chevy cavalier ls how to get the crankshaft sensor out of the block also can I remove the oil pan to get to the crankshaft sensor
should not have one pre 1995 years
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.
Look on the engine side of the firewall in front of the clutch pedal. You should see the reservoir there.
It is on the bottom of the radiator. Sometimes it is easier to remove the lower radiator hose.
It is mounted on the driver side inner fender close to the battery.
I have a 93 Chevy Beretta and mine is located INSIDE my fuel tank so I would look there. in the fuel tank
Your fuel pump is inside the tank which is below the passanger rear seat. I have to change mine and this is how u get at it.
on the drivers side of the fuel rail part of the intake manifold, it has a vacuum line connected to the top of it.
it takes 2 people,1 to pump the clutch pedal and the other to bleed it from underneath at the clutch slave cyl. but remember to keep the reservoir full at all time. it is kind of like bleeding the brakes on your car
i don know how would a monkey fix it
There is no adjustment, The clutch it self is either worn out, Bad clutch slave cylinder. Air are no fluid in the clutch mastercylinder. Fill clutch master cylinder up with fluid, be sure to remove the little rubber cub that is inside of the clutch master cylinder before you fill it up, then bleed the clutch of all air. Then see if the clutch works better.
If it is the factory radio, then the pin-outs diagram should be stamped into the metal on the radio it-self.
How much oil does a 93 Chevy truck hold
probably the turn signal flasher it is located next to the fuse panel
There is no clutch cable in 93 Mercury Capri. Its operated by hydraulics. There is a clutch slave cylinder and master cylinder. the seal in it probably worn out. Not very hard to work with.
Will a 93 chevy silverato steering collum fit a 98 chevy silverato
Cavalier 1985-93 Top of Glove Compartment
Is this a manual transmission? If so, this is a pretty common problem for these cars. Probably going to have to replace the shifter cable. About $50 at Advance.
You have warped rotor(s). Replacement or machining of rotor(s) required to fix that condition.
To fix the temp gauge check the temp sending unit first. A bad sending unit is a common problem with the temp system.