Use a hammer and pound the stuck hub until its wedged loose then pull it off.
If it is a manual locking type on a super duty f250, replace the hub. it is held in by a wire clip. The wheel and wheel bearings do not have to come off to do remove it. The hard part is getting the hub to slide out as they can sometimes corrode around the outside edge. Just clamp a tool on it as a handle and start tapping it side to side with a hammer while pulling, and it should come out. The hubs should be available from many sources and should not be extremely expensive. Standard duty f250s with body like the f150 may be different.
If it is the auto hub is can be a vacuum problem. I have seen some hubs where a snap ring came loose on the inside and just needed reassembly
Yes , the 2000 Mercury Mystique is front wheel drive
The 2000 Odyssey is a "front" wheel drive vehicle.
The 2000 Ford Focus is a front wheel drive vehicle
Front Wheel
front wheel drive
how do i replace front wheel bearinbs on 2000 ford ranger 4wd
The oil filter is on the lower left (drivers side) front, side of the engine.You can see it if you look over the left front wheel.
The 2000 Pontiac Firebird is rear wheel drive
Front
no its not Yes is is front wheel drive with an autostick tranny
no , it's front wheel drive
Yes