Chevy Blazer

How do you fix a loose windshield wiper on a 2002 Chevy Blazer?

232425

Top Answer
User Avatar
Wiki User
2014-09-18 00:21:31
2014-09-18 00:21:31

If a windshield wipe arm is loose on a 2002 Chevrolet Blazer, it likely needs to be replaced. It probably has a broken connection.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Check your owners manual, it will tell you in that.

User Avatar

How do you Change Windshield Wiper Blades on a 2004 Chevrolet Trail Blazer?

User Avatar

The 1983-1994 Chevrolet Blazer S-10 (sometimes called "Compact Blazer") takes 16" replacement windshield wiper blades on both sides front. The 1989-1994 models also take a 14" rear wiper blade.

User Avatar

if its not mounted to the firewall just above and at the rear side of the motor then it is on the opposite side of firewal bellow the wiper arms

User Avatar

Yes, there is a windshield wiper relay on a 1992 Chevy Lumina. The windshield wiper relay is located in the underhood fuse panel.

User Avatar

where is the fuse for 06 chevy cobalt windshild wiper

User Avatar

If the windshield wipers won't turn off on a 2000 Chevy Blazer, check the wiper relay switch. This is usually located in the engine compartment fuse box on top of the battery.

User Avatar

All 1995-2005 Chevrolet Blazers take 20" replacement windshield wiper blades on both sides front. The rear wiper blade is a 14".

User Avatar

The 2004 Chevy Malibu windshield wiper relay switch can be found on the firewall in the engine compartment. The windshield wiper relay switch will be on the drivers side of the firewall.

User Avatar

it is the same reservoir as the front windshield. In my 93 the front reservoir also supplies the rear.

User Avatar

The wiper motor is located under the black plastic cowl below the windshield.

User Avatar

turn signal & wiper relay for a 1998 Chevy blazer

User Avatar

the fluid for the rear wiper comes from the same reservoir as the front windshield wipers. it is located in the engine compartment by the fuse box. the rear windshield wiper will run out of fluid before the front wiper though, so just make sure the reservoir is full

User Avatar

its connected to the windshield washer jug

User Avatar

Replacing windshield wiper fluid is very easy to do in a 1995 Chevrolet Blazer S 10. The washer bottle is located under the hood. There is a small plug at the bottom that will drain any remaining fluid. After the old fluid is drained, replug the bottle and fill with new fluid.

User Avatar

The module is located on the front side of the wiper motor on the fire wall it comes as a separate unit it can be purchased at local parts store for about $30 dollars three screws hold it in place.

User Avatar

This happened with my 2002 Blazer. The windshield wiper switch also had an effect on the radio. The dealership found two weak electrical grounds and that solved the problem.

User Avatar

The relay is attached to the bracket that holds the wiper motor to the hatch.

User Avatar

The switch for the rear wiper will be on the dash, to the left of the steering wheel.

User Avatar

Its attached to the windshield wiper motor you will have to remove the cowl to get access to it.

User Avatar

No. See sources and related links below for wiper blade info.

User Avatar

The 2000 Chevrolet Malibu windshield wiper relay switch is located on the firewall in the engine compartment. The windshield wiper relay switch will be on the drivers side of the firewall.

User Avatar

The 2002 Chevy Trailblazer takes 22" replacement windshield wiper blades on both sides front and a 16" rear wiper.

User Avatar

The wiper motor on a 1998 Chevy Venture is up under the vents next to the windshield. It is bolted to the firewall.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.