answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you fix a messed up threads on harmonic balancer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you fix a harmonic balancer on a 2001 Chevy impala?

There is not much you can do with a bad balancer other than replace it with a new one.


How do you fix a 1993 Honda civic that wont start no power to the distributor and the fuses are not blown?

Check your timing belt, harmonic balancer and the either two or three belts that connect to the harmonic balancer


Oil leak from harmonic balancer Chevrolet 350?

The oil leak is probably comming from the top of the oil pan there is a rubber gasket that goes between the oil pan and the water pumb which would make it look like its comming from the harmonic balancer, try replacing the oil pan gasket this should fix the problem. New answer: There is a small round oil seal / Harmonic balancer seal that fits in the timing cover and the balancer slides through the center of it. That is probley were your oil leak is. Most of the time the balancer itself gets a groove wore in it over time from that rubber seal running on it. You can repair the balancer by buying a Harmonic balancer repair sleeve/ speedy seal. Also replace the front timing cover seal.


How do you fix it when the ribs on the lowest pulley come off on 1990 buick century?

I believe that is the harmonic balancer. If that has failed, you will get engine vibrations at the lower speeds. It should be replaced.


1990 camaro rs v6 and you had replaced the distributor and messed up the timing how can you fix it?

well first you need to get the timing close enough to crank then put a timing light on it and bring timing to top dead center.. which is the second mark on the timing chain cover.. there will be a mark on the harmonic balancer line that mark up with the second mark on the gauge on the timing chain cover.. and should be fine


How can I fix a messed up registry?

Reformatting is the best solution for a messed up registry.


What does it cost to get a harmonic balancer fix?

I had mine replaced on a 92 PA ultra. The Ultra has two serpentine belts, so it is a little more expensive than a single pulley. My total cost was just under $200 with the labor cost being about $100.


How do you take off a harmonic balancer off a 1991 Toyota Camry?

dude, i just tried this myself on a 1993 4cyl. Camry and went by all the step the repair manual says to do. seriously take my advice and just let a mechanic shop do it for you. if you do it yourself and try to get the bolt off the pulley, your going to just make the timing belt skip around in there and mess up the timing of the engine. i had the intake cam held down with a wrench like instructed to while trying to loosen the bolt on the pulley. that is when the gear just jumped the timing belt inside. You'll have to do so much more harder of stuff to get the whole engine in time again. its a hard fix because the bolt is lock-tighted down Alot! I'm having a mechanic come to my house today to fix the whole shabang and its gonna prob be a huge shabang on my wallet since i tried to do it myself! just having a mechanic do it for you shouldn't be over 200$ id imagine. I'd pay it in a heart beat! hope this helped! ----------- DO NOT attempt to loosen the harmonic balancer bolt by holding the camshaft. You will destroy the timing belt. You have to lock the flywheel with a pry bar or heavy screwdriver then loosen the harmonic balancer bolt. By now your fan belts should be off then get out your harmonic balance puller. DO NOT use a three jaw puller as you will destroy the harmonic balancer. You can rent a harmonic balancer puller at many auto parts stores or they are fairly inexpensive to buy.


How much should labor be to fix a harmonic balancer on a 2000 Chrysler 300m?

I live in Arizona. I just got a quote at my usual repair shop, because they spotted a wobble in mine. This shop wanted a total of $215, ($135 for the part, $80 for labor) -Greg


Where is the engine mounts for a 1994 Oldsmobile cutlass supreme?

There are many. There is one located under the harmonic balancer, on top of the engine in front, 2 at the tranny as well. Depending on which one is bad it can range from a easy fix, to a very complex repair. You can join http://www.w-body.com/forum/index.php for lots of information and help to fix your car.


How do you fix a messed up hairline?

Go to a professional barber.


Where is the cover of the timing belt of a subaru legacy 1991?

Hi! Your timing belt cover is right on the front of the engine. It's a big, long, black plastic piece consisting of 3 separate pieces when taken apart, just behind the large pulley on the lower front of the motor(Harmonic balancer). After you pull off the harmonic balancer, there are a number of 10mm bolts to remove before the cover comes off. Really easy as timing covers go! I love these cars because they are so dependable and easy to fix! Good luck!