replace the inlet needle and seat. If you cant replace the seat then clean with a q- tip.
The float could be stuck because of stuck needle valve, or rust. The float could also be leaking and be full of fuel.
how do u fix code 36 on a 2008 polaris 500 efi
Usually the float valve in the carb is bad . The valve will not stop the fuel and it runs down the cylinder into the crankcase .
You probably have a stuck float or the carb is out of adjustment or choke is stuck on. hope this helps
Please specify which part you want to fix (I.e. brakes, tail lights etc)
Remove the float from the Regal. inspect the float for leaks, then check the spring and needle valve as it could be stuck. If all parts are ok then the parts need cleaning as they are sticking.
Your float is stuck, a quick fix is tapping on the float bowl with a wrench or the handle of a screwdriver, but you need to tear your carb down and give it a good cleaning.
Could be bad gauge or float stuck in fuel tank
Remove them with some WD-40 and some vice grips.
Return it to the store and buy a "Polaris Pool ATV." I like mine so much I named it.
Put it in neutral and push it in reverse for about 500 feet it should kick out.
You might be able to but it depends on how it is bent. Many different ways to fix it but you want to make sure that the fix does not weaken the frame, but instead strengthens it. May even be better to find a used undamaged frame. I happen to have one but I am located in NC. Not sure where you are at.