Replace the pump, your bearings are shot and it needs to be replaced before the pump flies apart sending your fan through the radiator.
One of the easiest but to do it right , get a manual on your car.
no
To change the water pump on a 305 Chevy motor, start by disconnecting the negative battery terminal and draining the coolant from the radiator. Remove any components obstructing access to the water pump, such as the fan shroud and belts. Unscrew the water pump bolts and carefully detach the old pump. Clean the mounting surface, apply gasket sealer to the new pump, and install it by reversing the removal process, ensuring all connections are secure and refilling the coolant.
Yes, a Chevy 305 water pump can fit a Chevy 350 engine, as both engines share similar designs and mounting configurations. However, it's important to ensure that the water pump is compatible with the specific year and accessory drive setup of your engine. Always check for differences in inlet and outlet locations, as these can vary between models. For the best results, consult your vehicle’s service manual or a trusted mechanic.
To remove the heads on a 305 Chevy, first disconnect the battery, carb and throttle cables. Also disconnect the sensors and vacuum hoses. Unplug water temp gauge sensor on the thermostat and disconnect pump from brackets.
timing chain is inside the timing chain cover which is located between block and water pump. the water pump mounts to the front of timing case There is a cover that is behind the water pump... The timing chain is under that cover.
65 ftlbs
Yes it will, as long as you are swaping from a 305 to a 305.
Yes
Look at your timing scale the 305 times from behind the water pump & the 350 times in front of the water pump.
it's inside the oil pan
Passenger side, front, lower on the motor.