Your holding tank is "water logged". There is an air bladder in the tank that requires a specific pressure (dependant on the tank size). Some possible causes are a loss of air in the air bladder (just like a tire looses air over time), or the bladder has a tear or hole in it.
Underneath the washer holding tank is the pump motor.
you gotta find and remove the top tank plug - drain some water from the tank bottom to let some air get in the tank top and replace the top plug.
It is possible that the expansion tank on a boiler could have too much water and not enough air, causing leaking. To fix this problem, the tank should be adjusted to the right levels of each.
You've likely blown the air tank, which is why it doesn't hold any air pressure anymore. There's not much you can do when the air tank is broken, but you could try to identify the leak by opening up the blaster and searching for air holes in the tank.
Most military flamethrowers have a pressure tank, holding compressed gas to push the fuel out of the weapon, and a fuel tank, holding liquid fuel. There is no air inside the tank. If a shot penetrated the fuel tank while it was under pressure, it would spray fuel (that may ignite), but would not be likely to explode.
Beaker Bottle Vessel
how much to fix a gas tank on a 93 grand cherokee?
How do you fix an airlock in a 2002 ford explorer gas tank.
take it to the fix place...................................................................................................................................................................................................................................................................
AchXh9 fuwkceenroiz
Do you mean a drain for the freon? If so, there is no drain. It needs to be evacuated and stored in a holding tank by law.