The brake light failure sensor on a 1997 Acura 2.2 cl is located on the rear of the car. It is on the back of the left rear lamp assembly.
It means one of the brake lamp bulbs is blown or maybe there's a wiring problem. In any case, your brake lights are not fully functional.
Usually at the upper end of the brake pedal under dash area
i have a 2001 acura cl 3.2 and the code p1709 keeps coming up and the drive light flashes. how do i fix this
To replace the rear corner lights on a 1998 Acura CL open the trunk. Find the brake light housing and disconnect the bulb. Install the new bulb.
Under the dashboard above the brake pedal.
No model year given... Here's the general Acura CL brake light bulb lamp replacement procedure: Purchase the correct replacement brake light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement brake light bulb information. Then consult your owner's manual for the replacement procedure. As simple as it sounds, the owner's manual is the best place to start for brake light bulb lamp replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Acura CL was created in 1997.
check out this website. Even though it says Honda its for the acura cl.www.installdr.com/InstallDocs/Honda/PDF/466037.pdf
how to change alternator in acura 1999 cl
where"s the solenoid for a acura cl 2001
Coupe luxury