The question does not make sense; ICMP isn't broken - it is the protocol for informing other devices or users that there are problems on the network, or for control messages in general.
There really is no "port" for icmp but there is a icmp code. If you are looking for the icmp code for echo-reply it is 0 and the echo is 8 For an access list you could do the following: permit icmp any any echo-reply permit icmp any any echo Or the same using the icmp code permit icmp any any 0 permit icmp any any 8
There really is no "port" for icmp but there is a icmp code. If you are looking for the icmp code for echo-reply it is 0 and the echo is 8 For an access list you could do the following: permit icmp any any echo-reply permit icmp any any echo Or the same using the icmp code permit icmp any any 0 permit icmp any any 8
ICMP does not have a port like TCP and UDP.
Because ICMP is on the network layer
All ICMP Error Messages
icmp request is orginated on the OSI network layer with ip protocol.
Because ICMP traffic, notably ICMP ECHO REQUEST-0 and ECHO REPLY-8 are used in network diagnostic sequences.
ICMP is the internet control access protocol . ICMP is the plrotocol that should be allowed when not able to ping a remote device residing behind a firewall. ICMP is the protocol of network layer.
If devices on a network are properly configured, a host sending ICMP to a default gateway must receive a reply. ICMP simply means ping.
Assuming IPv4 ICMP. Ping uses IP for transport. Ping in itself is an "Echo Request", which is a function of the ICMP protocol. The IP Packet will carry the ICMP protocol from end-to-end. ICMP has a protocol number of 1, so the "Protocol" field in the IPv4 header will contain "1" as a reference to the ICMP payload. For IPv6, ICMPv6 is used, and the transport will be IPv6.
no
Ping request