Want this question answered?
mass air flow sensor
unbolt tranny from engine clutch is between them
Replace the PCV Valve.
haynes manual
you can't fix a sensor, you can replace one by removing it and installing the new one...:)
== == depends a lot, first start with removal with the door panel and look for any unhooked rods connecting to the locking mechanism Add lots of lubicant on metal rod where they connect to locking mechenism had problem this winter door will not open
i put a new windshield wiper moter in and the fuses are fine but my wipers still wont work
if your horn wont go off its a short to power or faulty conector
Check your intake hose...mine did the same and i noticed there was a crack in the hose.. hope this helps
it should be an assembly with the fuel pump. if it is or if it is not you still need to drop the tank to get to it. with the tank out from under the vehical you will be able to see where it goes.
"Intake Valve Timing Control Position Sensor, RH Bank 2" wouldn't think it would be too much to fix on this car.
It is located right behind the glove compartment. Remove the glove box and you'll see it. IIRC, it's a white piece. It should be an easy fix.