Pull egr tube and check for blockage. clean as required and clear code. if code come back replace sensor
The little tube along the passenger side of the engine will be plugged with soot at the thermostat housing.
A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.A 1997 Dodge with a Cummins diesel does not have an oxygen sensor.
The exhaust back pressure sensor on a 2006 6.0 diesel Ford F3 50 can be located near the exhaust manifold. The sensor is a probe that can be removed by loosening the nut.
A Ford diesel diagnostic code P0470 means there is an exhaust pressure sensor malfunction. This may be caused by faulty exhaust back pressure sensor, or pressure sensor is open or shorted.
Cummins (OEM) 12 valve (single wire) oil pressure sensor is located below the injection pump and could be in front of or behind injection pump support bracket. The location was determined by the factory installing the engine. Cummins (OEM) 24 valve (three wire) oil pressure sensor is located below the ECM.
It doesn't have a mass airflow sensor.
A 2000 Dodge Ram diesel does not have an oxygen sensor.
On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.On the Cummins diesel the crank sensor is located in the side of the block under/behind the starter.
On the fuel filter!
No such part on a 1993 Cummins
In 2004, the Dodge Cummins Diesel was not equipped with an oxygen sensor. The 2007.5 and newer Cummins 6.7 liter Bluetec diesels have an O2 sensor in the downpipe. Typically, only particulate filter equipped diesels have O2 sensors.
1997 Dodge diesels come with the 12 valve cummins engine. It is fully mechanical and does not have a camshaft position sensor. "Dodge cummins diesel forum" is a good resource for dodge cummins owners.
The 2005 Peterbilt M 11 Cummins diesel engine map sensor is located next to the fuel pump. The map sensor should be labeled as such.