To change the high-level brake light on a Renault Espace, first, ensure the vehicle is turned off and the keys are removed. Open the tailgate and locate the access panel or screws that secure the high-level brake light assembly. Remove the panel or screws, disconnect the old light bulb or assembly, and replace it with a new one. Reassemble the access panel or screws, and test the brake light to ensure it’s functioning properly.
To remove the high-level brake light on a Renault Clio Mark 3, start by opening the tailgate and locating the two plastic covers on either side of the light. Carefully pry off these covers using a flathead screwdriver or a trim tool to expose the mounting screws. Unscrew the screws holding the brake light in place, then gently pull the light assembly away from the tailgate. Disconnect the wiring harness to fully remove the brake light.
Replace the whole unit - it's got LED inside, not bulbs unfortunately
The probable cause of the brake lights not working on your Renault is the brake light switch. The brake light switch can be found under the dashboard by the foot pedal.
If the dash stop light stays on in your Renault Laguna, it typically indicates an issue with the braking system. This could be due to low brake fluid levels, worn brake pads, or a malfunction in the brake system itself. It's important to check the brake fluid level first and inspect the brakes for any wear or damage. If the light remains on after addressing these issues, it's advisable to consult a professional mechanic for further diagnosis.
It could fit a T10.
To reset the parking brake on a Renault Scenic, first ensure the vehicle is on a level surface and the ignition is on. Press the brake pedal and then pull the parking brake switch up to engage it. Next, keep the brake pedal pressed, and then push the switch down to release the parking brake. If the warning light remains on, consult the vehicle's manual or a professional, as there may be an underlying issue.
To change the rear high-level brake light on a Renault Espace, first, open the rear hatch and locate the plastic cover or panel that conceals the light assembly. Carefully remove this cover using a flathead screwdriver or trim removal tool, taking care not to damage the clips. Once exposed, disconnect the wiring harness and unscrew the light assembly to replace the bulb. After installing the new bulb, reassemble everything by reversing the steps.
Check to see if the brake fluid level in your brake master cylinder ( in your engine compartment ) is low , if the brake fluid level is low or your parking brake is on the brake light in your gauge cluster will come on
Check the brake light switch.
The brake light in the dash comes on if the parking brake is engaged or the brake fluid level is low in the brake master cylinder in the engine compartment
Have you checked the brake fluid level in your brake master cylinder in your engine compartment ? a low level will turn on your brake light in the dash