0
to replace the ignition Module on a v6 3.1 or 3.4 you must remove the coil pack from the the back top of engine. this coil pack is were the spark plug wires plug into. make sure to label wires be for removal it will help when going to reinstall. the coil pack is held in place by four bolts on a aluminum bracket. remove bolts and wires along with the three connectors ( two on one end and one on the other) each coil is bolted to the module by two 5.5mm bolts. remove the bolts and the coil will pull right off the module. repeat for all three coils. once coils are off module will be off.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you fix a noisy speedometer on 1982 Olds Cutlass?
Sounds like the cable needs to be lubricated
How to fix 1987 olds cutlass ciera radiator fan will not stop running?
Thermal relay is stuck. Replace it.
I have a 91 olds cutlass ciera emergency flasher don't work but turn signals does how do i fix this?
check your fuse
How much will it cost to fix timing belt on a 93 olds cutlass?
1000+ to start you may have done valve damage
Purchase a Replacement gas cap 1999 olds cutlass?
Any parts store should be able to fix you up.
How do you fix power window on a 1993 olds cutlass supreme?
maybe you can look in the fuse box located under the glovebox and replace the electrical fuse.
How do you replace the key ignition on a 1999 Oldsmobile Cutlass Currently I cannot turn the key at all?
I'd call a locksmith. They will be able to tell you the exact problem and how to fix it.
How do you fix 1995 c1500 modulator valve?
That year transmission did not HAVE a modulator valve. That year used a 4L60E / And the E stands for electronic transmission. NO valve. It is all computer controled.
How do you fix a Modulator on Ford E250 Van?
Take it to a Ford garage or someone who is familiar with Modulators
How do you fix a short in the ignition sweitch?
You don't. You change the ignition switch.
How do you fix a broken horn on a 1993 Ford Ranger XLT?
I had this problem with my olds cutlass. the fix was too simple. There is a relay in the horn circuit. I took it out and pushed it back in-working horn again.simply put the contacts had oxidized ... it might help if you also spray contacts with electrical cleaner-can get it at parts store or hardware.. Good Luck
How to fix a 1996 Pontiac grandam ignition locked?
Replace the ignition lock cylinder.
