How do you fix the play in a 1986 Camaro even after the steering box has been replaced?
i have a 1992 camaro rs, they play in mine went away after replacing the bushings on the front lower control arms and bushings
1998 aurorarack and pinion was replace and power steering pumpstill leaking power steering fluidwondering why?
seems like the steering pump should have been repaired or replaced
there has been a recall on power steering for the 05-2010 cobalt check with your local GM dealer and have it replaced
it could be the shearing pin fitted in most cars to stop thieves breaking the steering lock, could have been damaged when you took it out, or the splines on the lower knuckle joint not connected
Bought 1994 Ford Ranger the power steering pump had just been replaced but power steering fluid is leaking you have to top it off every 2-3 days?
check your gear box
Be sure to check suspension components. Namely the tie-rods...
Unless steering or suspension parts have been replaced - they are usually sealed at factory (no lubrication fittings)
Turn signals on your 1994 Pontiac grand prix come on but do not flash .flasher has already been replaced?
Check bulbs could be bad switch in steering column
Unless steering or suspension parts have been replaced - most likely a sealed (no grease fittings) system
The Apple Lisa was launched on 19 January 1983 and was discontinued in August 1986 having been replaced by the Macintosh.
What do you if you disconnected the battery replaced the rack and pinion steering reconnected the battery and the car still not start?
Check your wire from battery to starter, sounds like it may have been pulled loose.
yes you can or at least as far as i have been told and read. all you need is a new steering wheel with audio controls Ive priced them at the dealer for about $150 and worst case scenario is that you have to replace the clock spring under the steering wheel but the truck should already be wired for it.
When you drive your 1986 Jetta it over heats and stalls then wont start again til it cools down. the radiator and the thermostat have been replaced?
Is the fan functioning?
What is the problem with a 1999 Riviera if the turn signals are not working even after all lights and the flasher have been replaced?
It's either in the wiring but more likely in the turn signal switch (in the steering column) itself.
I've been working on an 85 Oldsmobile with a V8 and I replaced the power steering pump. There are about three holes on the pulley itself, line one of the holes up with a nut on the other side of the pump and loosen to move the pump along a bracket.
most of them are on a recall from gm,, they did mine twice, then it was still there, all they do is pop the steering wheel off and grease down the tube. my noise came back , and after having the powersteering pump take a dump, and i replaced it , wah la , the noise is now gone,,, so i believe the noise has alway's been with the faulty power steering pumps and not… Read More
1986 grand marquis has power to the coil but no fire from the coil to the plugs the coil has been replaced and still nothing what else would be wrong?
Replace the ignition control module
Believe Saleen as it has been modified while Camaro SS is a stock Vehicle
the stock engine for an iroc z is 5.7 ltr v8 tpi with 220-230 hp. i know ive been driving one since 86 when i bought it new.
could be that one of the belt driven components, such as power steering pump, alternator....etc, has a worn internal bearing. Reason being, is when the new belt is replaced, the tension is usually tighter causing more stress on the pulley and bearing.. Tom
I've been having trouble getting it straight too, but it was either a 1976 Chevy Camaro, or a 1977 z-28 Camaro. It was not a 1974, no matter what you hear.
If your steering wheel is vibrating or jimmying while under normal driving conditions this indicates that your tire are out of balance, or have been worn incorrectly. You may have a bad alignment, bad control arm bushings, improper toe/chamber or the wrong tire compound. If your wheel vibrates while turning, then your power steering pump is failing, and needs refurbished or replaced immediately.
2001 Chevy Silverado 2500HD and the power steering pump is vibrating really bad when you press the brake pedal and when you turn the steering wheel what could cause this?
The front brake rotors are warped. It's not the power steering pump if it only happens when braking. One or both of the rotors need to be replaced. Overheating causes this, especially if the rotors are old or have been turned as part of a previous brake job on the truck.
= FERA has been replaced by FEMA =
One amendment has been replaced
Why will the security system on a 1989 Chevy Camaro RS work fine some days and others not allow the car to be started even though the censors have been replaced and new keys have been tried?
I had a problem with that on my car and it was cause by someone hook the wire up wrong and grounded out the electrical and had to take it in and get wired right
What causes a 1986 camaro to lose power to the fuel pump when all of the wiring has been checked out with the motor?
loosing power to the fuel pump could be a shorted wire, if that were the case you would have blown a fuse, also your fuel pump could have gone out
After the steering wheel on a 1996 Saturn got wet the horn startled blaring then finally stopped now it doesn't work the fuse has been replaced how else can this be fixed?
You are going to have to take the steering wheel apart and clean it out. As this will entail removing the driver's airbag, I suggest you have this done by a professional. Serious injury can occur when tampering with SRS.
Its possible your new keys don't have a matching resistance value to the car. There are 15 different resistance values, and your local dealership can look up what the value should be if you can provide proof of ownership.
1986 Chevy s-10 blazer and it has been stalling after approximatley 10 mins of running the starter rotor distributor cap spark plugselectronic control moduel been replaced any ideas?
Did you replace the fuel filter?
Almost 75,000 2010 Camaro's have been made. The Camaro made it's come back in 2010. The plant that the Camaro is built at is the Oshawa Plant.
Other than the introduction of the $2 coin and the withdrawal of the 1 and 2 cent coins, Australian coins have not changed much since 1986. The Queen has aged a little. The paper Bank notes of the past have been replaced with colourful polymer notes.
no luckily, it hasen't been replaced... yet
How do you Repairing power steering in a Pontiac grand prix 1986 its leaking is it hose or pump time to learn?
I asked the question: I was lucking I just had a hole in the holes they patched it for 40 bucks never think any things broken till your sure... was told if it was the pump I should of not been able to move the steering wheel at all.
I just replaced my fuel pump myself for 106.00 dollars. had i got it done at a shop it would have been around 400.00. sure its not your relay
Mustang would beat almost any muscle car by racing. Mustang has been known to beat the camaro. Motortrend has been doing tests and so has edmunds and Mustang has been beating the camaro since the 90s the new 5.0 mustang has been a huge popular car as one of the fasest mustang's and the camaro has been out of business since 2005-2009. Mustang's are a classic to ford and the mustang shelby gt500 2010 has… Read More
If your struts have been replaced two times and the mounts have been replaced in the past 4 months and the car rides as if the struts sound old what could the problem be on a 1998 Camry XLE?
were the struts put together right? squeek- possible control arm bushings clunk- spring pads "struts", control arm bushings, swaybar links or sway bar bushings, loose steering parts depending at what speed
WEP has been replaced by WPA.
What is wrong with my 1986 Oldsmobile delta 88 It has been in the shop for 2 years. Almost everything has been checked or replaced. During cranking it backfires through the breather housing?
Either incorrect firing order or way to much advance in the timing.
Steam engines have been replaced by electric motors for most applications.
you cant get it to work when it has been replaced.
Why would the turn signals quit working when the hazard lights still work and the flasher and bulbs have been replaced on a 1995 Chevrolet Corsica?
Check the flasher for the turn signals which is under the dash on the left side of the steering column . It is different from the emergency flasher.
You hit the side of a 2ft mud bank on side of road and since then you get bad steering wobble the offside front tire has been replaced but you still get bad wobble it can be felt all over the car?
Possible bent tierod.Have your local garage check it out.
What would cause the steering to pull to one side during heavy braking but not during light braking The rotors calipers wheel cylinders have been replaced on front and rear.?
My guess would be that you might have a bad brake hose to one of the front calipers.
Take your Serpentine belt back off. Try to start the car now. If it starts, shut it off quickly. Spin all the pulleys under the hood, power steering, alternator, AC, idler, tensioner. See if they all spin. If one doesnt, it probly needs to be replaced.
Jobs as simple as checking out at stores have been replaced by computers and many others.
Is a substituted hydrocarbons that contain halogens what atoms have been replaced by the halogen atoms?
Hydrogen atoms have been replaced.
my 91 Chevy Camaro RS V8 engine will not rotate when I turn the key the battery and the starter have been checked
How to adjust steering wheel back to center after installing a new upper control arm on a 1998 dodge ram 1500 4X4?
That is something that needs to be done at an alignment shop. Toe-in has been affected when you replaced the upper control arm and you probably affected caster and camber as well. When a good alignment shop adjusts the front end they will also put the steering wheel back to center.
What are some problems you may have from your Chevy Camaro v6 3.4l that has been parked for over a year?
Stale gasoline Leaking power steering seal Leaking transmission seals Belts and hoses dried out and cracked and/or brittle Brake fluid evaporated or shellaced Battery dead Tires dried out and cracked Frozen engine rings