Car Electronics and Lights
Headlights Tail and Brake Lights
Dashboard Lights and Gauges
Mitsubishi Lancer

How do you fix your dash lights on a 2003 Mitsubishi Lancer ES even though the fuse is not blown?

545556

Top Answer
User Avatar
Wiki User
2015-07-15 20:07:20
2015-07-15 20:07:20

to change the lights you remove the dash cluster and replace the bulbs. the number for the bulbs are 197

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

If dome lights and sunroof of a Mitsubishi Galant are not working, it is probably due to blown fuse. It is time to replace old ones.

User Avatar

check fuse 4 or 5 under the hood, i can almost promise its blown, i had the same problem. my plate lights, tailights and dash lights didnt work.

User Avatar

Sounds like, though unlikely, you have 2 blown fuses. I don't know a lot about Dodges but I know on Chevy and Ford the instrument lights and brake lights are on 2 separate circuts but I would check the fuses first. If you pull the fuse and you are not sure if it's blown, just replace it as sometimes it is hard to see if the fuse has actually blown or not.

User Avatar

Test if your hazard lights work. There are normally two flasher cans in most vehicles. If the hazard lights work, It is likely to be the flasher can that works the indicators is blown and in need of replacement. These will be available for under $50US from most auto parts stores.

User Avatar

fuses are blown, or bulbs are blown

User Avatar

Pull the fuse out and have a look at it and if the wire inside is broken then its blown

User Avatar

Yes, it certainly could be a blown fuse.It could be that the lights have burnt out as well.

User Avatar

mostly likely when you got the overcharging a fuse or relay was blown. need to locate and replace fuse most likely but possibly a relay.

User Avatar

Tail lights are usually on the same fuse with interior lights and dash lights. That is so you will know when the fuse is blown. Brake lights are usually on a different circuit. If a fuse is blown, try to figure out the cause rather than just replacing the fuse.

User Avatar

A blown fuse would cause the hazard lights not to work on the 1994 Ford F150. It could also be blown bulbs causing the lights not to work.

User Avatar

Flasher relay is bad if the lights come on but do not flash. If they lights do not come on at all then the bulbs may be blown or the fuse if blown.

User Avatar

Blown fuse or the lights are just blown and need replacing.

User Avatar

your fuse is blown. car manufacturerers make the dash lights go off when the tail light fuse blows so you know it is blown.

User Avatar

These are on the same fuse. Check for a blown fuse.

User Avatar

Bad switch. Open wiring between switch and lights.

User Avatar

Possibly blown fuse, bad brake light switch, or blown brake light bulbs.

User Avatar

check your fuses first, if none are blown, check the bulbs if none are blown, then take it to a shop you've got a wiring issue.

User Avatar

You have got a blown fuse. These lights are all on the same circuit.

User Avatar

Blown bulbs, blown fuse, broken or out of adjustment brake light switch.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.