Want this question answered?
pull the strap in the trunk then push the seat down
09 chevy impala rpm jumps up and down
Unless it is the Luxury edition, the seats do not fold down.
down uner the glove box
The back seat of a Chevy Cavalier is a split bench seat. The release for the seat is located in the trunk behind the split. Simply pull the release and fold the seat down.
There are five steps on how to remove the back seat in a 1997 Chevy Malibu. Some of the step-by-step instructions are open the trunk lid, pull the top portion of the backseat all the way down, and then pull the top portion of the backseat all the way down and locate the hinges from which the seat pivots.
Down same tube that holds trans dipstick.
I don't believe they had that option back in 1976.
behind the alternator near the firewall about 3" down
The bottom portion of the seat will pull out but the back of the seat will have to be unbolted and then slid out to access the trunk.
In order to get the backseat to fold down in a 2004 Chevy Cavalier, you need to go through the trunk. There should be two straps, one on either side of the seats. Sometimes, these straps get pushed into the cracks, so be sure to look thoroughly. Pull either one of the straps to fold down the seat. The seats will fold down as one section. Some 2004 Chevy Cavaliers were shipped without the option to fold down the backseat, though the number is very few.
If the Impala is the same as my 2001 Monte Carlo with a 3.8 L engine, the resivoir is on the pass. side way down low in back of engine compartment. You need a bright light to see it and it is very hard to get at!