answersLogoWhite

0


Best Answer

Try taking pressure off of the ignition switch by turning steering wheel. If that does not work try taking the handle of a screw driver and placing it against the ignition switch. Gently tap the end of the screwdriver with a hammer. This may be a temporary fix, but should keep you from needing a tow.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you free a 2002 Suburban ignition that the key wont turn?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Ignition switch will not turn Replace?

Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?


Why will my My 2002 suburban turn over but won't start?

Is the fuel pressure ? is there spark at the plugs?


2002 impala ignition key hard to turn why?

it is either the key is worn out or the key cylinder in the ignition is worn out.


How do you turn off security system on 1999 chev suburban?

turn the ignition switch on (all the lights in dash light up) but do not crank engine. leave on for half hour untill security light goes off. turn off ignition, wait 30 seconds then start engine.


Is there a dash warning on 1995 Suburban for faulty spark plug?

any ignition misfire should turn on check engine light or make it flash


The ignition and starter is locked in place in my 2002 Kia Sportage. How do I fix this?

I've had the same happen with multiple cars. The trick is to try to turn the steering wheel just a tiny bit (it will be difficult because the steering has no power) while you turn the ignition. Usually the tug on the steering wheel will dislodge the steering wheel lock and free the ignition to turn. Once I learned this trick it saved me a few trips to the mechanic.


Why would the radio in a 1998 Chevy Suburban come on by itself after you turn off ignition and remove key?

Well sometimes the radio is hooked up to the ignition itself. It is just the ignition wire, if it has a disconnecting face plate then you can turn it off by taking the face plate off. Or if you would like, you can pull the radio out and disconnect the wire from the ignition and it will not still be on when you cut the truck off.


How you reset change oil light 2002 suburban?

Turn key on , do not start. Push gas pedal to the floor 3 times turn key off, then start engine.


How do you Turn Daytime Running lights off on 2002 suburban?

hit your dome light on/off switch 4 times...it says how to do that in your manual


How do you turn off the service light on a 2002 transit van?

If you mean the orange light showing oil can and spanner hold both foot brake and throttle, turn on ignition and hold for 30 seconds. The light will flash, turn off ignition job done.


I have a Dodge Caravan 2002 - When I turn the key - I hear clicks on ignition - but engine wont start?

Your battery is dead. Turn your lights off next time.


How do you reset the change oil light on a 1999 Chevy Suburban?

turn on ignition switch and press and release the accellerator three times slowly within 5 seconds. turn if switch and recheck. if fails the first try it again.