Try taking pressure off of the ignition switch by turning steering wheel. If that does not work try taking the handle of a screw driver and placing it against the ignition switch. Gently tap the end of the screwdriver with a hammer. This may be a temporary fix, but should keep you from needing a tow.
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
Is the fuel pressure ? is there spark at the plugs?
it is either the key is worn out or the key cylinder in the ignition is worn out.
To reset the anti-theft system on a 1999 Chevrolet Suburban, first ensure the vehicle is in the "Off" position. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in the "On" position for about 10 minutes; you should see the security light turn off after this period. Afterward, turn the ignition back to "Off" and then start the engine.
turn the ignition switch on (all the lights in dash light up) but do not crank engine. leave on for half hour untill security light goes off. turn off ignition, wait 30 seconds then start engine.
any ignition misfire should turn on check engine light or make it flash
I've had the same happen with multiple cars. The trick is to try to turn the steering wheel just a tiny bit (it will be difficult because the steering has no power) while you turn the ignition. Usually the tug on the steering wheel will dislodge the steering wheel lock and free the ignition to turn. Once I learned this trick it saved me a few trips to the mechanic.
Well sometimes the radio is hooked up to the ignition itself. It is just the ignition wire, if it has a disconnecting face plate then you can turn it off by taking the face plate off. Or if you would like, you can pull the radio out and disconnect the wire from the ignition and it will not still be on when you cut the truck off.
Turn key on , do not start. Push gas pedal to the floor 3 times turn key off, then start engine.
hit your dome light on/off switch 4 times...it says how to do that in your manual
To reset the throttle position on a 2002 Lexus ES300, first ensure the ignition is off. Then, turn the ignition to the "ON" position without starting the engine and wait for about 10 seconds. After that, turn the ignition off again, and start the engine. Allow it to idle for a few minutes so the system can relearn the throttle position.
If you mean the orange light showing oil can and spanner hold both foot brake and throttle, turn on ignition and hold for 30 seconds. The light will flash, turn off ignition job done.