answersLogoWhite

0

magnet on a stick. Such tools are in existence and can be purchased from any automive parts store.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Will a 91 Jeep wrangler with a straight 6 transmission fit 94 Jeep Laredo with a v8?

It would fit in the engine compartment, but nothing would line up or bolt up correctly.It would fit in the engine compartment, but nothing would line up or bolt up correctly.


Where is the oil drain plug 2006 new jetta tdi?

Take the skid plate of the bottom of the engine compartment. The oil drain plug is located on the back center of the oil pain. It's a 19mm bolt.


Is the hood hinge the thing that connects the hood to the fender?

Yes, the hood hinges bolt to the hood and then go down and bolt underneath of the cowl that runs across the front of the engine compartment.


Where does the top starter bolt come through the engine compartment on a 19 70 beetle?

It's behind the fan shroud, so I hope you have skinny little arms and a way to get the hood off because it is TIGHT back there.


How do you open battery compartment zx9r?

There's a small ratchet bolt right behind the seat in the rear compartment, undo that then the front seat should lift and back out, make sure you lock the seat back in right when putting back together!


What is the biggest engine that can fit in and bolt up to your 1971 ford f-100?

this is a tricky one because the engine compartment is large enough to fit any ford engine ever produced or any other passenger car or truck engine for that matter. as far as your truck if you want it to bolt in then it depends on what was in it to begin with


How do you remove the jack on a 1992 jeep wrangler?

The jack on the 92 should be inside the engine compartment, near the battery, held down with a bolt and strap.


Is engine 3970044 2 bolt or 4 bolt?

i have a engine with this # and its a 2 bolt main


Where is a sport tracs computer?

It's located on the firewall inside the engine compartment, just below the the wipers. A bolt in the center of the conector holds the connector/harness into the computer.


How do you change the fuel filter on a Honda 1997 crv?

This job should be done while the engine is cold and the ignition switch is in the OFF postiion. The filter is located on the firewall of the engine compartment. (1) Relieve the pressure in the fuel system by opening up the gas tank filler cap and opening the fuel line at the fuel filter by loosening the banjo bolt. (2) Place towels around the filter and remove the banjo bolt and unscrew the threaded fitting. Remove the clamp bolt and lift the filter out of the engine compartment. Re-installation is the reverse of removal.


How do you change the fuel filter on Honda CR-V 1999?

This job should be done while the engine is cold and the ignition switch is in the OFF postiion. The filter is located on the firewall of the engine compartment. (1) Relieve the pressure in the fuel system by opening up the gas tank filler cap and opening the fuel line at the fuel filter by loosening the banjo bolt. (2) Place towels around the filter and remove the banjo bolt and unscrew the threaded fitting. Remove the clamp bolt and lift the filter out of the engine compartment. Re-installation is the reverse of removal.


Where is the oil drain bolt on a Peugeot 306 estate?

Under the engine, towards the back of the sump.