Want this question answered?
If you can get a hold of a product called "Once Off" by morgan Adhesives then this is your best bet. Goodluck!
You CAN place tile over tile, but saying you can put tile over tile is like saying you CAN jump off of a bridge. It's just simply not a good idea. It can cause air pockets to be created under the tile laid on top, which can lead to cracked tiles if anything is dropped on them or sometimes simply by walking on them. It's worth the time to go ahead and strip the tile off of the floor before laying any new tile.
You can tile over existing tile although it isn't reccomended. You would be safer by removing the tile and then installing the new tile. But, if you wanted to tile over existing tile you would have to make sure all the tile is even and not lose. If the tile is lose or uneven it will caused the new tile and grout to crack or pop out.
To replace the decorative tile border on a concrete pool, the pool will have to be drained. The old tile needs to be taken off and a new tile with waterproof grout or concrete can be installed. The pool should dry for a week or so, before it is refilled.
The new tile can be glued to the old ones. If possible, stagger the new ones so that they attach to two tiles. If you have to cut the first row in half, you can use the piece you cut off on the other side of the room.
It would be better to remove the old tile, then put your new tile in it's place. If you tile over the old there is a chance it could come off and your new tile with it. I know of an adhesive swimming pool tile border made of 4mil liner, its a peel and stick called borderlines adhesive tile manufactured by Jedco Products. All the internet websites carry it and it looks great, it would stick right over the old tile, this could get you by until your ready to remove the old tile.
Yes, but you need to scrape or chip off as much of the old mortar as you can - both from the back of the tile and from the floor, just enough to ensure that the tile will set level.
The toilet should sit on top of the new tile.
To cut ceramic tile, use a tile cutter or a wet saw. With a tile cutter, score the tile's surface using a scoring wheel, then apply pressure to break it along the scored line. A wet saw uses a diamond blade to make precise cuts, with water cooling the blade.
It depends on the tile, but it will come off only with water.
Sure can, but if its waxed tile you should rough it up unless there's a chance its got asbestos in it. Then use a primer sealer over that top to give the glue something to bind to. Also remember that the new tile is only as good as the old tile that's down. If the old stuff comes loose your new tile job is shot.
It depends on the type of ceramic adhesive. Many of them can be taken off tile with lacquer thinner on a rag.