Best Answer

There are several safety mechanisms for the Chevy Corsica. if you accidently left the car out of park when you turned of the car, in some models if your lights are left on it wont let you take out the key.

User Avatar

Wiki User

โˆ™ 2009-04-29 00:57:11
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: How do you get a key that is stuck in the ignition out of a 1991 Corica Chevy?
Write your answer...
Still have questions?
magnify glass
Related questions

What is the ignition timing for a 1991 Chevy Camaro RS?

8 degrees

1991 Chevy S-10 is stuck in park?

well if your s-10 is stuck in park there is a good chance the transmission is bad in it.

Why would nothing happen when the key is turned on a 1991 Chevy Blazer?

Probably ignition switch. Have it checked out.

What is the BDCT ignition timing degree on a 1991 Chevy Suburban 5.7?

you should set it at 0 degrees btdc

Why would you not get a spark after replacing the ignition coils and spark plug wires on a 1991 Chevy Cavalier?


Where is the ignition control module located on a 1991 Chevy Lumina AVP 3.1?

If you have disributorless ignition it will be mounted under the coil pack . If you vehicle still has a distributor it will be in the dist.

What is the ignition timing for a 1991 Chevy s10 blazer 4.3 tbi?


Does the 1991 Chevy Silverado have an ACC position on the ignition switch?

Yes. After inserting the key, turn it counterclockwise one click.

Your 1991 300zx has no power to the entire car and the key is stuck in the ignition?

If your 300zx has no power to the entire car and the key is stuck in the ignition you have to press the emergency button located in the ignition. Simply remove the black piece from your ignition.(its a black cap)..and when removed you will see a small red button..if you see that push that and press the "push" black button, turn your key and pop it out.

Is there a button somewhere that releases the key so you can get it out of the ignition in a 1991 Ford Probe GL?

I own a '91 GL and no there is not. It sounds like you may have an issue with your ignition lock being stuck. Have never taken apart an ignition before. -Shaun

How do you replace the ignition cylinder in a 1991 Chevy Corsica?

Not an easy job requiring special pullers and tools. I suggest taking it to a garage.

Where is iat sensor on a 1991 Chevy s10?

If it is a Vortec it will be inside the tube running from the intake to the air filter it is a rubber hose with this stuck in it!

People also asked