Want this question answered?
I don't believe you can display both the radio station and the clock at the same time. With the radio on push the "CLK" button, that will display the time and I believe when you change radio stations it will display the station # temporarily before returning to the clock display.
11
The Chass Port of Call clock is a popular attractive design which allows the setting of multiple time zones for display at the same time.
A clock. Ha ha ya shoulda known.
the "clock", with a display typically marked off multiples of the "second"
Setting the clock Use these instructions to set the clock. 1 Use MULTI-CONTROL to select CLOCK SET in the initial setting menu. Refer to Adjusting initial settings on this page. 2 Press MULTI-CONTROL to display the setting mode. # Press DISP/BACK/SCRL to return to the previous display. 3 Press MULTI-CONTROL to select the segment of the clock display you wish to set. Each time you press MULTI-CONTROL, one segment of the clock display is selected. Hour—Minute As you select segments of the clock display, the selected segment blinks.
Press and hold the clock button for at least 2 seconds. The hours on the clock will flash. Use either the Tune/FF-REv or Seek/Track button up or down arrow to adjust the hour up or down. Press the clock button again and the minutes on the display will start flashing. Repeat the process. When the clock has been set, press clock again and it will return (stop flashing.) It will return to normal clock display in 10 seconds, or you can press clock one more time and it will return to the regular display setting. These instructions are right out of the owner's manual.
An analog clock is one with an analog display (that shows you the time by means of a flat dial marked with the hours of the day and one or more pointers (hands) that point to the time of day on that dial). A true analog clock should also have a mechanical means for keeping the time and driving the pointers.Conversely a digital display would show you the time directly as numbers which change as the time passes and a true digital clock would calculate the time using a digital/electronic mechanism (a computer).
Time can be the formatting of clock times. There is also a function called Time which can display a time combined of hours, minutes and seconds.
If you cut off the hot power that goes to the radio all of the time, that will turn the clock off BUT you will not have any display or presets.
Setting the Clock for Systems with SET ButtonPress SET. Within five seconds, press and hold the SEEK right arrow until the correct minute appears on the display. Press and hold the SEEK left arrow until the correct hour appears on the display. Setting the Clock for Systems with HR and MN ButtonsPress and hold HR until the correct hour appears on the display. Press and hold MN until the correct minute appears on the display. To display the clock with the ignition off, press RECALL or HR/MN and the time will be displayed for a few seconds. There is an initial two-second delay before the clock goes into the time-set mode.
Press the clock adjust button on the back. The display will show 12h or 24h. Press and hold clock adjust button for about 2 seconds. Display will begin to flash. On the top right of unit there are two buttons that are labeled 'hour, min, sleep" Use these to adjust the time. Once the time is set, press the clock adjust button again.