to take off a drum of your rear brakes you need a flat head screwdriver. simply place the screwdriver through the crack between the drum and the axel and pull in your direction all the way around and this should loosin the drum being able to get to your brakes
Most auto-parts stores that sell brake drum assemblies will also provide you with an assembly picture. The brake drum assembly pictures can also be found at most local libraries.
No , disk brakes front and rear ( the back disk brake rotors have small parking brake shoes inside of a drum portion )
Sometime the brake shoes will rust or freeze to the drum. TAke it to a garage.
Brake drums can be resurfaced by turning the brake drum in a brake drum lathe. When the brake drum has deep grooves in it, it cannot be repaired.
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
The wheel cylinder has failed and will need replaced.
A drum brake is a brake that uses friction caused by a set of shoes or pads that press against a rotating drum-shaped part called a brake drum. The term drum brake usually means a brake in which shoes press on the inner surface of the drum.
There may be a problem inside the brake drum.There may be a problem inside the brake drum.
The drum and the brake shoes.
In case of cost..drum brake is better than disc brake.
If the rear brakes are drum brakes remove the wheel slide the drum off and check brake lining if brake lining is good then at the bottom of the brake assembly turn the adjuster wheel out. Check by putting drum on and spinning the drum until it spin 1 to 1 1/2 times around. If the car has rear disc brakes check brake pads probably needs to be replaced
just did that use small chisel hammer screwdriver if no puller