You need two special tools, A 36mm wrench and a spanner to hold the pulley still. While holding pulley yo use 36mm wrench and a hammer to turn fan nut counter clockwise.
loosen the idler pulley and then remove the belt. then you remove the fan shroud i believe its like 4 bolts, then you remove the fan. after that you can remove the water pump.
What about it? Remove the fan shroud, remove the fan itself, unbolt the water pump.
That is the water pump pulley.
How does the belt for fan and water pump go on a 2000 Jeep Cherokee Sport 6 Cylinder?
Radiator, fan, water pump, hoses, heater core, thermostat, engine block, radiator cap,...
Sawsall.
behine fan bottom of van
Its on the front of the engine. The pulley with the fan.
The water pump is the part that the radiator fan screws onto on the front of the engine.
Water pump attaching bolts: 30 ft-lbf Fan-to-water pump attaching bolts: 200 inch-pounds
on the front of the motor behind the fan
The pulley is part of the pump assembly. I don't think it comes off. The clutch fan unbolts from there. Is that what you mean?