0
How do you get more horsepower out of a 4.0l inline six motor?
Wiki User
∙ 12y ago
first you could buy a performance intake system such as a K&N cool air intake. second you could buy a performance exhaust system such as flowmaster, magna flow, and Gibson also would suggest performance headers with max air flow low resistance. there are more ways to but it involves a complete engine overhaul such as possibly boreing the cylinders to get bigger performance pistons, performance connecting rods, performance piston rings, performance ignition system, performance valves and springs, and also there is a chip for the computer for some models that will increase horsepower. those are just some ways of increasing horse power they are many more ways. consult a performance shop for recomendations for proper parts and procedures.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many cm3 are in 40L?
40L = 40000cm3
Would a gasoline tank hold about 40ml or 40L?
On a car, 40 liters.
The person name that killed Aaliyah?
The pilot-operator of the Cessna 40l which fatally crashed.
Where is the fuel filter on a 1995 Jeep Wrangler 40L?
Look under vehicle foolow the fuel line from the tank
Is there an access door for a fuel pump on a 96 4 door 4x4 40L explorer?
No door. You have to drop the tank.
Where is the fuel filter on a 1997 Jeep Wrangler 40L?
It's part of the fuel pump assembly located inside the gas tank.
Engine removal procedure98 explorer 40L V6?
Get a Haynes or Chiltons manual from an auto parts store and don't forget to label everything.
Where can you find a vacuum hose schematic for 1995 40L AWD aerostar?
It is located underneath the hood. You might have to clean it off with a rag to read it.
What is the oil to petrol mix for a dt15 suzuki outboard?
My mechanic says 100:1 I have done this for 40l last season without a problem
Can you fit a 50 mustang engine in a 1993 ford explorer xlt 2x4 40l v6?
i would deffinatly say yes since some of the year models came with a 5.0 stock.
Your 1993 wrangler 40L inline six will crank and rollover but will not start replaced distributor wires plugs starter ignition coil map sensor throtle position sensor fuel pressure good?
If it's not the crank sensor, it's probably the ECM, and that's bad. Try you crank shaft position sensor, if it is bad the engine will not run. It's on the back of the engine just below the vavle cover on the drivers side You can also try the ignition pickup. It's a little back plastic plate that sits on top of the distributor when you take the cap off.
Where is the oil pressure switch located on a 93 Ford Ranger 40L V6?
the oil pressure switch is located on the left side below the power steering pump. it is about 1.5 - 2 inches and about 2.5 inches long
