0
What else can I help you with?
Why does your 1998 jeep miss when you hit a bump?
Look for a loose plug, or plug wire.
Why does your Jeep Wrangler backfire when you hit a bump?
Look for a loose plug, or plug wire.
How do you fix burnt blower motor wiring on a jeep?
Either replace the burnt wire or run new to the blower motor with a toggle switch.
What colour is earth in a plug?
The color of the Earth wire in a plug is typically green or green and yellow stripes.
What plugs into a blower motor resistor?
the black and red wires with the square plug goes into the blower motor. the other plus is constint power wire, ground, and ign switch wire.
How do you install msd street-fire on 1997 jeep tj?
The big question is what wire go's where. On my 97 Jeep Wrangler Sport I wired as follows; First: the gray tach wire and magnetic pickup are not used, Second: the heavy red (pos +) and black (neg -) to the battery, the 4 remaining wires will hook up between the coil-pack plug and harness. Cut the plug off leaving enough wire to attach the street-fire (S/F) wires. So let's start with the plug, my TJ colors are solid Gray and Green/Black stripe. Attach the S/F Orange to the Green wire on plug; attach the S/F Black to the Gray wire and plug it back in the coil. On the harness side attach the S/F White to the Gray wire from the harness; attach the S/F Small Red to the Green wire from the Harness. Close the hood and go.
How do you attach a three prong plug wire with a green white and black wire to a shop light with a black wire and white wire?
The green wire is for ground. You can attach that to any metal part of the frame. The red is the active and coincides with the lefthand prong into the plug and the black in this case should be the Neutral and ciocides with the right prong into the plug as seen standing behind the plug.
How do you wire a GFCI plug?
To wire a GFCI plug, first turn off the power to the circuit. Then, connect the black wire to the brass screw, the white wire to the silver screw, and the green or bare wire to the green screw. Make sure to follow the manufacturer's instructions and test the GFCI plug to ensure it is working properly.
What is significance of red black and green wire in three pin plug?
The significance of the red, black, and green wires in a three-pin plug typically corresponds to their functionality. The red wire is usually the live wire, the black wire is the neutral wire, and the green wire is the earth wire. These colors help to identify and properly connect the wires for safe and correct electrical wiring.
Wiring diagram of jeep wagoner spark plug wire?
What is the firing order for a 2.5L 4 cyl. engine in a 1985 Jeep Wagoneer?
How do you wire up a 2003 Jeep Liberty Sport for a tow trailer?
AnswerGo to your local auto parts store and get a towing light kit. It will plug directly into your wire harness in the back of your jeep.
1990 cadilliac heater blower motor will not run checked fuses relay all test ok what do I check next?
Test The Plug On The Blower Motor For Voltage If It Has Voltage Test The Blower Motor If Its OK. Most Likely Your Plug Is Bad Loose Or Broken Wire If So Replace It. Good Luck Remove The Wire Pluged Into The Blower Motor, Test To See If You Are Getting Voltage. Also Check The Plug On The End Of The Wire You Removed. You Will Most Times Find A Bad Connection. Like A Wire Loose Or The Rubber Deterated. Buy This Plug If That Is What You Find. Get Some BUTT Connectors Install The New One. Be Sure To To Correctly Get The Colors Right. This Should Take Of It.
