Run a hot (12 Volt) wire straight to the motor with a jumper to the wire that allows up. Be careful as you can get hurt doing this.
1995-1999
remove pwer window switch disconnect wires. using another wire, bridge the wires in swith to complete circuit window will go up
I have a 1996 Monte Carlo and my driver power window had stopped working so I thought it was the window motor but I went to the junk yard and got several different master switches off of old Monte Carlos and found one that work and switch the old one with the new and it WORKED!!! =)
Should be in the power distribution block under the hood My fuse box on my 2000 Monte Carlo is at the end of my dash on the drivers side..To acsess the door must be open..
bad switch or contacts
take the door panel off and disconect the wire assembly or window regulator that goes to the power window moter and manually pull the window up.
My brothers 2003 Monte Carlo had this problem, was a plugged catalytic converter.
Take the switch out of the door and you can jump it just like you jump start a car.
MY DRIVERS WINDOW WAS STUCK IN THE DOWN POSITION, I CHANGED THE WINDOW SWITCH BUT IT DID NOT HELP, I FOUND OUT THAT WHEN I USE THE EXPRESS DOWN THE WINDOW STICKS IN THE DOWN POSITION. I BANGED ON THE DOOR PANEL AND IT STARTED WORKING. NOW I DO NOT USE THE EXPRESS AND I DON'T RUN THE WINDOW ALL THE WAY DOWN TILL I CAN SWAP IT OUT
THERE IS TWO WAY BY A HAYNES MANUAL OR GO TO AUTOZONE.COM VEHICLE REPAIR INFO.
You need to purchase a Haynes Manual so you can see what to do to keep from breaking something.jd
It is serviced in the power steering reservior.jd