It is best to leave the blister alone and let it heal naturally. However, there are times when this technique is not practical.
I have used the following technique for decades treating blisters developed during hiking excursions and forced road marches in the Army. Sterilize a pin/needle. Poke the pin down into the good skin just beside the blister, then up under skin where the blister is. This will allow you to drain the liquid from the blister while protecting the area under the blister. Cover the blister with antibiotic ointment and a bandage. I have found this to relieve the pressure and the pain.
I have a blister on my Foot and it has been there for a while and nothing works...
First, find a safety pin/needle
Second, sterilize the safety pin/needle with Bactine (or peroxide)
Third, get toilet paper or napkins (1-2)
Fourth, take the safety pin/needle and slowly insert the safety pin/needle into the blister.
Trust me! It doesn't hurt!
Fifth , you will see this juice come out! It's a good sign! Make sure that you get all of the juice out with the napkins.
Finally, spray the last bit of the blister with Bactine or put peroxide on it so it doesn't get infected.
This should take at least 2 minutes at the most. It will feel much better afterwords! I hope you find this useful!
P.S.This is from Wiiplayer.Another way is to wait until it dries,then scratch it off.It hurts a bit,but it works.Alternatively,you can just pop the blister open.
it also happens if u dont talk you could write in a notebook it makes it smaller if you dont talk
another way you could get rid of a blister would be to squeeze 2 lemons and rub the left overs on the blist
I am a figure skater and I have had so many painful and annoying blisters, I am the blister expert now. lol. Here's what to do if you have a blister.
1. Clean the blister and surrounding area with soap and water.
2. Sterilize a small sewing needle by cleaning it with rubbing alcohol.
3. Slip the needle into four different places around the blisters surface (NOT on top. If you puncture the blister directly on top it will HURT! Put the needle in 4 different places around the edge of the blister, or where the raised blister surface meets your regular skin.
4. A runny clear liquid will come out (it literally looks like water). Wash the blister again with soap and water.
5. Rub some Neosporin cream onto the blister, and the surrounding area (if it is sore as well). It doesn't have to be Neosporin, any kind of healing gel/cream will help. (Aloe Vera is also excellent.)
6. Place a special blister band aid over the blister. These band aids can be found at drugstores, Walmart, Target, Kroger, etc. These band aids are made of a special material and have a certain type of gel already in the band aid for advanced healing effects.
If you do all these things and don't irritate the blister any further, it should heal in 2-3 days.
put Vaseline on it before you go to bed and wrap it in a sock...it may sound stupid but it works!!!:)
blood blisters are painful but put plasters on or put a ankle protector on (if on ankle)
Well first you want to put a tough skin baindaid and vaseline on your blister and then put two layers of sock over top of it or them.
Put salt on a spoon and keep it on the blister for 30 sec and repeat 3 times
You probably won't be able to completely get rid of a blister caused by a temporary crown. You could call your dentist and see if they had any recommendation. You could use Orajel to help with the pain.
Get a spoon pour a little salt on it and pour right on the blister it will sting a little and the salt will dissolve right on but it heals supper fast
( 🐶 ) Dog Medicine
You can't. It will take its time. They usually long 8 to 10 days.
It would hurt, you'd probably get a blister, but you are unlikely to get rid of the wart.
You get a needle and hold it over a candle or fire and when it gets really hot pop the blister. The heat is to get the needle sterile. If the blister is in a high-use location, like inside the hand, you can prevent it from tearing open later by inserting the sterilized needle BESIDE the blister and coming up from the underside into the blister, then squeezing the blood or fluid out that way. The top layer of skin lays flat and can actually bond back together instead of splitting open. Good luck!
I've never used vaseline to get rid of a blister ! All I do is use a pin to prick it then, using light pressure and a tissue, soak up the fluid that comes out. I leave it 'open to the air' - to let it dry out, then remove the 'scab' after a few days once it's toughened. The skin underneath always fades to normal.
The meaning of the 'blister' in blister copper is for that fact that its appearance is caused by the escaping sulfur dioxide which gives it the blister look.
A blister on the labia
Blister Agents
Your blister pops...