0
depending on how large your hot tub is, you can just use a pool shark. they plug into the wall, and move around the bottom of the pool, or hot tub if you like. they are really neat, they are basically underwater vacuums.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you get the tub treads off the bottom of your fiberglass tub?
run hot water and soap in the tub and scrub
How do you get wynut in pokemon emerald?
There is an egg in the city where you can battle flannery. A women will give it to you. She is in the sand below the hot tub.
What is the internal pressure of hot tub filters?
Hot tub filters contain sand and gravel to filter our impurities in the water via a high pressure nozzle. The pressure must be high enough otherwise circulation problems may occur.
What is the hot tub on YoVille all about?
THE HOT TUB IS TO RELAX
How can I use a hot tub cover?
You use a hot tub cover after the hot tub has cooled off. Using it while your hot tub is still warm can cause your cover to break.
Pool chemicals in a hot tub?
What about "pool chemicals in a hot tub"?
How much does a hot tub cost?
for a luxury hot tub it is 15,000
How long do hot tub covers last?
Hot tub covers can have long lives if they are cared for properly. Hot tub covers are mostly affected by dirt and sunlight so keep it clean and perhaps put a tarp over it if the hot tub is in direct sunlight.
How expensive are hot tub covers?
Hot tub cover prices usually depend on the type of hot tub that you own. Hot tub cover prices can range between $100 to $400. It also depends on your income to decide if a hot tub cover is too expensive.
Will sand and grit ruin your hot tub?
I work at a hot tub factory building hot tubs. I also fix hot tubs. Sand and grit will not ruin a hot tub immediately but it will definitely increase wear on many components. Long term exposure will decrease the time before things start to go wrong. The components that could be affected are: 1. Jet inserts: They could stop spinning, stop turning on/off, or fall apart. 2. Pumps: The impeller can wear rapidly and decrease water flow from constant sand impact. 3. Heater element: The heater element is usually in direct contact with fast moving water. Coatings on the element can be worn away by sand impact which can cause them to fail sooner. Solution: Remove sand often! A cheap and easy way to do this is to siphon it out with a length of hose > Submerge the hose in the hot tub to fill the hose completely with water > Hold your hand over one end of the hose > Drop that end with a few extra feet of hose over the edge of the tub onto the ground while making sure the other end stays under the water in the tub > The water will start to siphon out > Now use the submerged hose end to suck up sand and grit from the tub. -- Dont forget to remove the hose when done or your tub will be empty next time you check it!
Why should I purchase a hot tub heater?
A hot tub is just that a tub of hot water thus, the need for a heater. To reek the benefits and pleasures of owning a hot tub a heater is an essential element to the experience.
Does going in a hot tub make you tired?
Only during the time in which your are in the hot tub. After leaving the hot tub, all prior weariness will have evaporated.
