1) Pull of the engine cover (unless you have the V-6, then it's not there anyways)
2) There is a plug and a hose on the inlet
a) Plug: gently remove the entire assembly, b) Breather hose: Pull firmly to remove from the intake, it may take a bit of effort.
3) using a screw driver, loosen the clamp at the throttle body until the intake hose starts to move.
4) Unclip the airbox cover and pull the intake out of the engine compartment.
5) Remove the air filter and remove the bolts and the rest of the stock air box.
Now you're ready to put in your aftermarket intake - or you just took out the factory intake for fun!
The 2006 Dodge Charger has a V6 engine.
The 2006 Dodge Charger has a 3.5 L base engine size.
The 2006 Dodge Charger's engine produces 250 hp @ 6400 rpm.
The 2006 Dodge Charger's engine produces 250 ft-lbs. @ 3800 rpm.
take a look at the intake tube (between the air box and the engine) it is the larger plug on the backside of the stock intake.
that all depends on what engine you have in your charger.
The 2006 Dodge charger knock sensor is located on the back of the engine. The knock sensor will be near the bottom of the engine cover.
Depends on what engine it has...
Depends on what engine it has...
Depends on what engine it has...
Just like any other 2006-2010 Dodge Charger
It should be the plug on the intake just before the Throttle Body.